Does the Pop & Lock Custom Tailgate Lock Come With Instructions

Question

Question:

Does this part have instructions ?

asked by: Ric D

0

Expert Reply:

Yes, the Pop & Lock Custom Tailgate Lock # PAL1100 will come with installation instructions. I have also attached the instructions below for your reference.

expert reply by: Robin H

0

PL1100 Instructions.
(click to enlarge)

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 4

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 5

Hey Kenny, welcome back! The reason for that note is because all of the new systems since 2025 use R32 refrigerant due to EPA regulations. Any 2024 and older systems use R410A and their parts are not compatible with the R32 units. It doesn't mean…

view full answer...

Answer 6

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 7

Hey Tim, I checked out your Predator 5000 generator and it does use a quick connect propane connector like what the part #CAM57629 provides so yes this would work. How do you like the Predator generator?

view full answer...

Answer 8

The brake wire providing voltage is wired in parallel, with one lead from each magnet being grounded to the trailer frame. We have a great Wiring Help Page that shows a diagram, I will provide a link to it below.

view full answer...

Answer 9

The biggest difference will be capacity. The Curt Hitch part #C15302 that you referenced is on the high end of the capacity spectrum. It's a Class V hitch that has the following capacities: Maximum gross trailer weight: 16,000 lbs Maximum GTW…

view full answer...

Answer 10

We do have an option for replacing your Elixir ELX-60. Unfortunately there is not going to be a direct replacement for the converter section. You will need to replace the entire panel with the Progressive Dynamics 4500 Series RV Converter…

view full answer...

Answer 11

Even on manufactured trailers wiring colors can vary so there is no way to say for sure. The only way to know which wire is tied to which function is to trace the wire back. On an SAE standard 7-way the brown wire would be the tail/running lights. On…

view full answer...

Answer 12

Hey Frank. I can give you the dimensions of the shank on the B&W Continuum item #BW28FR but you're going to need to take the measurements on your Silverado 3500 to confirm the tailgate will open. From the hitch pin hole to the center of the…

view full answer...

Does the Pop & Lock Custom Tailgate Lock Come With Instructions

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching