Curt Front Mount Trailer Hitch Receiver Cutout For a 2021 Ram 1500 Big Horn Built to Serve Edition

Question

Question:

Front mount hitch receiver I am looking for a front mount hitch receiver for a 2021 ram 1500 Big horn crew cab 4 x 4 built to serve edition with an E torque engine what would be the best hitch and wheel I have to trim any of the lower panel

asked by: Tom

1

Helpful Expert Reply:

The Curt Front Mount Trailer Hitch Receiver # C87FR will fit your 2021 Ram 1500 Big Horn Built to Serve edition truck. It will require you to trim out a 2.5" x 2.5" section of your lower fascia panel. I have included an image to show what must be trimmed.

The WeatherTech BumpStepXL Hitch-Mounted Bumper Protector and Step # WT81BS1XL is great to fill the receiver hole. It will help protect your front bumper and provide the additional step to access under your hood.

expert reply by: Bud M

1

Trimming For Curt Front Receiver # C87FR
(click to enlarge)

2021 RAM 1500 Big Horn Built To Serve
(click to enlarge)

Answer 1

The Curt Front Mount Trailer Hitch Receiver #C87FR will not interfere with the automatic air dam on your 2021 Ram 1500. See the attached photo which shows the hitch installed on a Ram 1500 like yours. The automatic air dam can be seen in the lower…

view full answer...

Answer 2

I would be happy to answer that question for you. The main difference between the Curt Front Hitch Receiver item #C87FR and the Draw-Tite Front Hitch Receiver Item #65081 is the difficulty in installation. The Curt is way easier to install. You have…

view full answer...

Answer 3

I am not sure but I think it's probably going to be difficult to cut that square hole accurately and feed the receiver through it while the air dam is installed. The installation process for the Curt Front Mount Hitch item #C87FR is the same on…

view full answer...

Answer 4

For the 2022 Ram 1500 with the eTorque engine the front hitch you'd want is the Draw Tite part #65081 which I confirmed as a fit for your truck unless it has factory tow hooks. The Curt you mentioned does not fit your truck. At this time Curt…

view full answer...

Answer 5

The hitch pin will end up behind the air dam of your 2020 Ford F-250 when you install the Curt hitch part #C31078 on it. Once cut the air dam is very easy to flex so that you can access the hole as needed.

view full answer...

Answer 6

I attached a picture of how the Curt front hitch part #C31069 will look when installed on a truck like your 2014 Chevy Silverado 1500. The hitch pin hole is right behind the air damn. It is a little hard to see in the picture so I put an arrow on it…

view full answer...

Answer 7

Hey David, it sounds like you know what you're doing but I've also gone ahead and found the wiring diagram for the Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR for you to check out so you can use it as a cross…

view full answer...

Answer 8

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 9

Hi Stan! The SnowBear Snowplow for 2" Hitches - 82" Wide x 19" Tall #K2AVAL8219 and Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2" #C31018 will definitely work on your 2013 Ford F-250 4x4. We actually have both of these…

view full answer...

Answer 10

Hey Dean, the Detail K2 Elite Snowplow part #K2AVAL8219ELT that you referenced comes with all of the electrical components it will need to install. It wires to the vehicle battery as well as comes with a wired switch that you would run to the cab of…

view full answer...

Answer 11

Hey Erik, It's common for the light on your Furrion stove's knob to stay on if it senses that the oven is on. Since you're clearly not running the oven but it's still on and staying red instead of changing to blue that would indicate…

view full answer...

Answer 12

Hey Gary, great question. Both plows look pretty similar huh? That is because there is only one difference between them, confirmed by Agri-cover. Agri-Cover SnowSport LT Snowplow part #SS98GV it built to be used in both the front and the rear hitch.…

view full answer...

Curt Front Mount Trailer Hitch Receiver Cutout For a 2021 Ram 1500 Big Horn Built to Serve Edition

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching