Does the Sew-In RV Slide Tape 37281365 Use 3/8" Snap Clips

Question

Question:

Do you have 3/8” curtain snap clips on item # 37281365? The sew-in RV slide tape. My cousin in Sweden bought a 2005 Winnebago. She needs it for the windshield curtains.

asked by: Lilian

0

Expert Reply:

Yes, the Sew-In RV Slide Tape # 37281365 uses 3/8" snap clips. The clip measures 1/2" by 1/2" outside edge to outside edge. The clip measures 1/4" in between the teeth at the top of the clip and 3/8" inside the clip under the teeth. I have included a picture demonstrating this as well.

expert reply by: Scott S

0

Snap Clip Diagram
(click to enlarge)

Answer 1

You can use the Air Lift LoadLifter 5000 Ultimate Air Helper Springs with Internal Jounce Bumpers - Rear Axle #AL88298 with an in-bed hitch system like your B&W Turnoverball Gooseneck hitch #BWGNRK1110 (with overload springs) or #BWGNRK1100…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 8

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Does the Sew-In RV Slide Tape 37281365 Use 3/8" Snap Clips

Product Page this Question was Asked From

Continue Researching