Replacement Lens For PM 440 151

Question

Question:

My lens shows the numbers PM 440 151 on one end and Dot AP2-94

asked by: Ben

0

Expert Reply:

The Peterson Replacement Lens, part # 55-15R, would be the correct lens you are looking for. The lens measures 2 inches by 2-3/4 inches. The distance between the mounting holes is 2-5/16 inches. The mounting screws are included. I have attached a photo with the dimensions shown.

Another note is this replacement lens fits Peterson Square Trailer Tail Lights (432200 and 432400). Screw holes are located beneath original tail light side marker lenses for use with this replacement lens on the Peterson Square Trailer Tail Lights.

expert reply by: Jeffrey L

0

click to enlarge

John

3/16/2020

My trailer lens Part# PM 440 151 DOT AP2 -94 does not have screw holes, it is snap in.DO you have these?

Reply

Chris R.

3/17/2020

The Petersen Replacement Lens # 55-15R that Jeffrey mentioned above is actually the right replacement for you. The original lens is snapped into place at the factory, but when replacing it the two screw holes and hardware are used for mounting. When you pop out the current lens you will see the two entry points for the screws (they are hidden behind the original lens).

Reply

Answer 1

This has come up before and we have reached out to Petersen directly about a replacement lens, and they told us that the Replacement Red Lens for Peterson Rectangular Side Marker Light w/ Reflector #55-15R is the correct replacement. When these…

view full answer...

Answer 2

The Peterson LED Clearance lamp you're asking about, part #M215A features a sealed LED and circuit board, so it is considered submersible and could indeed be used on your boat trailer.

view full answer...

Answer 3

For your broken Peterson PM 440 151 lens, the replacement part actually does have the screw holes. I spoke with my contact at Peterson and the correct replacement lens is the Peterson Replacement Side Marker #55-15R. In the manufacturing process when…

view full answer...

Answer 4

Thank you for the photo of your broken light lens for which you are looking for a replacement. It appears that your lens had two tabs for installation, rather than screws, with one of them now being broken off. I reviewed all of our replacement red…

view full answer...

Answer 5

While we don't have replacement parts for a Model 70LP actuator, we do have a great replacement for it. Like the 70LP, these actuators are a fit for a 2" hitch ball, but they just have a slightly larger capacity at 7,500 lbs. You didn't…

view full answer...

Answer 6

Even when stored in the somewhat controlled environment of a garage, tires are still subject to dry rot and flat spotting. Even if the tire tread has plenty of depth left and you can't see any cracking with the naked eye, the generally accepted…

view full answer...

Answer 7

Trailer tires - of any size - do not have any type of average life span; how long they last depends on a number of factors. One thing you will want to do on any trailer tire is always inflate the tire to the maximum cold psi. Doing this will give you…

view full answer...

Answer 8

The lens part #A11RB that you referenced measures 1 inch tall by 2-3/4 inches wide. This is the replacement lens for the part #MC11RB. I attached a picture that has dimensions of the light the lens fits.

view full answer...

Answer 9

The Camco RV Vinyl Trim Insert #CAM25202 that you referenced has an overall width of 1 inch. That's the size of rail it would fit into. I attached a picture that shows it's width for you to see as well.

view full answer...

Answer 10

If you said you need a 7-way trailer connector for your camper you can do a quick check to see if a 7-way is needed on your Jeep. Check the drums on the trailer to see if it has brakes. If you need a 7-way because the trailer has brakes installed…

view full answer...

Answer 11

Usually the actual part numbers for a trailer light will be found on the light's base or on its rear surface. The DOT codes you found on the lens are not part numbers, but since you took measurements of the lens we can check for a replacement red…

view full answer...

Answer 12

The Peterson Replacement Lens #55-15R is the correct replacement side marker lens for your trailer lights part #432200. Screw holes are beneath the original tail light side marker lenses for use with this replacement lens. In the manufacturing…

view full answer...

Replacement Lens For PM 440 151

Product Page this Question was Asked From

Continue Researching