Do You Carry The Yakima Gear Locker Enclosed Cargo Carrier?

Question

Question:

Do you have a Yakima GearLocker Enclosed Cargo Carrier for Modular EXO System - 10 cu ft ?

asked by: Jaechul H

0

Expert Reply:

We sure do!

We carry the Yakima GearLocker Enclosed Cargo Carrier as # Y44VR, and by clicking that part number you will be taken to the product page to make the purchase.

I included a video of the GearLocker for you to take a look at.

expert reply by: Samuel C

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

What that means is that the cross section of the hitch that runs side to side is completely out of sight once it's installed onto the vehicle. The hitch you looked at, part #C13065, has a hidden cross tube that you can't see with it…

view full answer...

Answer 3

The EXO GearLocker #Y44VR which is the enclosed cargo carrier for the Yakima EXO Swing Away Storage System w/ Enclosed Cargo Carrier and Cargo Carrier #Y44ZR has internal dimensions of 51 11/16" long, 17" wide, and 14 5/8" tall. I…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 8

Hi David! There are quite a few hitches offered for your 2026 Honda Odyssey, so I definitely understand wanting to know the differences. There are basically three styles available for you and I have them broken out below: Exposed Crosstube: etrailer…

view full answer...

Answer 9

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Do You Carry The Yakima Gear Locker Enclosed Cargo Carrier?

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching