etrailer Idler Hub Assembly to Fit 2K Dexter Trailer Axle Beam with Standard BTR Spindles

Question

Question:

Hello, does etrailer hub p/n AKIHUB-545-2-LF-2K for BTR Spindles fit the Dexter axle p/n T20BTR-7258? I assume it does, since BTR is in the part number, but there is no mention of BTR in the Dexter product description, so I just wanted to check with you folks to be sure. : Thank you!

asked by: Mike C

1

Helpful Expert Reply:

Yup, you're right on the money!

The Trailer Idler Hub Assembly for 2K Axles # AKIHUB-545-2-LF-2K is what you're wanting for the Dexter Trailer Axle Beam with Standard Spindles # T20BTR-7258.

Attached are some review videos for you to check out.

expert reply by: Jon G

1

Answer 1

I can absolutely understand not wanting to take your hub apart to find the right replacement hub, but unfortunately that is the only option as the numbers you referenced are not any type of indicator of a replacement. So, to determine the correct hub…

view full answer...

Answer 2

I reached out to Dexter and they no longer make that axle. I can confirm based on the bearing sizes you gave that you have a 3,500 lb capacity. If you determine you just want to replace the hub, I recommend the Trailer Hub and Drum Assembly for…

view full answer...

Answer 3

Thank you for the image of the axle tag for your Dexter D80 8,000LB axle. This will require the 10-36 Grease Seals #RG06-070 you found. Here is a list of the other components your axle uses should you want to replace or find any parts worn. Inner…

view full answer...

Answer 4

The Dexter "8-248" is a hub assembly for 3,500 lb axles that uses an L68149 inner bearing and a L44649 outer bearing. This hub assembly was offered in both 5 on 4-1/2" and 5 on 4-3/4" bolt patterns therefore you would need to…

view full answer...

Answer 5

Assuming your tires are in good shape without any bulges the easiest way to determine if you have a bent spindle is to take a straight edge that is longer than the tire and lay it across the tire parallel with your trailer frame and then measure the…

view full answer...

Answer 6

We have hubs that are designed to fit spindle diameters that you mentioned of 1 inch and 1-1/6 inch. If you have a straight spindle with a 1 inch diameter you'd have a BT8 spindle and the hub part #8-258BTUC1 that you referenced would fit. If you…

view full answer...

Answer 7

Judging by your photo, your trailer would use an idler hub, not a hub drum. Assuming you have 5 lug on 4-1/2 inch bolt circle wheels that use an #L44649 inner and outer wheel bearing, you have a few choices. Rather than the painted hub, I'd…

view full answer...

Answer 8

On Dexter axles manufactured after April 2001 you will be able to find the serial number stamped on the rear portion of the axle tube approximately 18" from the passenger side hub. Depending on the condition of the axle you may need some chalk…

view full answer...

Answer 9

What is your current tire size? The only tire size I saw mentioned online for a Flagstaff 176LTD is ST145-12 (also commonly referred to as 145/80-12). We do offer that size in a radial as part #AM10130 which is a load range D with a 1220 lb per…

view full answer...

etrailer Idler Hub Assembly to Fit 2K Dexter Trailer Axle Beam with Standard BTR Spindles

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching