Replacement Remote For Jensen JWM452 RV Stereo

Question

Question:

I need a replacement remote. Why the power harness when I just need the remote

asked by: Craig W

0

Expert Reply:

Jensen does not just offer the remote separate from the power harness for your Jensen RV Stereo # JWM45, instead they offer what's called the 'service package', which is why # JEN43RR also includes a replacement power harness.

Since it sounds like you do not need the harness, your best bet is to just store it somewhere until it is needed.

expert reply by: Bryce D

0

Answer 1

The correct replacement remote solution for a Jensen JWM452 is the part #JEN43RR.

view full answer...

Answer 2

The Jensen RV Stereo #JWM40 that you currently have is considered a Double DIN. Double DIN stereos are usually about 4" tall, whereas Single DIN are normally 2" tall. The Jensen RV Stereo #JWM70A that you mentioned is considered a Single…

view full answer...

Answer 3

For the Jensen RV Stereo we have the Replacement Service Package, #JEN43RR that includes power harness and remote.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Replacement Remote For Jensen JWM452 RV Stereo

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching