Recommended 2.5" E-Z Lube Grease Cap with Rubber Center Plug
Updated 06/03/2022 | Published 06/02/2022
Question:
I need eight 2.5 in rubber grease caps. or eight 1.84 in inner ID rubber plugs for boat trailer 7000 lb axles. It appears to have the ez lube s already. I have one cap only Used trailer no identifying marks on cap. thanks.
asked by: Richard P
0
Expert Reply:
It sounds like you're looking for the E-Z Lube Grease Cap part # RG04-080 which is designed for a 2.44" hub bore. Please note, the grease cap that is designed for the hub bore is an exact figure that needs to be taken with a caliper but this size is standard for larger 5,200lb + axles and that is 2.44".
expert reply by:
Conner L
0
Product Page this Question was Asked From
Grease Cap, 2.44" OD Drive In with Plug - Qty 2
- Trailer Bearings Races Seals Caps
- Caps
- EZ Lube Grease Cap
- 2.44 Inch O.D.
- 2.44 Inch
- 5200 lbs Axle
- 6000 lbs Axle
- TruRyde
more information >
Continue Researching
- Q&A: Recommended Soft Start for a Furrion AC Unit
- Q&A: Bearing Kit for 6,000 lb Dexter Axle
- Article: Trailer Brakes Not Working? Troubleshooting Guide
- Article: Trailer Wiring Diagrams
- Article: Most Popular Wheel Bearings
- Q&A: Can The MORryde RV Cargo Slide Tray Be Used If The Mounting Surface Is Smaller Than The Tray?
- Q&A: Can I Use an Adapter to Plug the 30 Amp ActiveStart Plug-In Soft Start to a 50 Amp Plug?
- Article: Trailer Maintenance Schedule
- Q&A: Replacement for Atwood 61101 Brake Actuator
- Q&A: Looking for Replacement Landing Gear Legs for Keystone Montana Fifth Wheel
- Q&A: Replacement Wheel Studs For 6,000LB Axle With 1/2"-20 Threaded Studs 2-3/4" Long
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Gooseneck to 5th Wheel Adapters