Replacement Hardware for a Curt C13397 Hitch

Question

Question:

I am specifically looking for 3 of the CM-SP2 Square Hole Spacers. I cannot find these listed individually on your site. I did manage to locate the three 7/16th fishwiresinch I will need, and I have the other bolts and nuts necessary, but I really need those three square hole spacers. Any help would be greatly appreciated.

asked by: Jorge G

0

Expert Reply:

I have a solution for you but the CM-SP2 spacers are not available for individual sale. However, there is a complete set of replacement hardware available for the Curt Trailer Hitch item # C11254. This complete set will allow you to install your hitch on your 2016 Hyundai Veloster and you won't have to piece it out or worry about using the incorrect/unapproved hardware and voiding your warranty. You will want the Replacement Hardware Kit for Trailer Hitches item # RHK. Just go to the right side of the product page above add to cart and insert the hitch model number C11254 and the manufacturer which is Curt.

We do have the Trailer Hitch Spacer Block - 3" Long x 1" Wide x 1/4" Thick item # RP3022 but you would have to modify them to make them fit.

expert reply by: Jerred H

0

Answer 1

The weld nuts were probably still dirty, when you were installing the hitch which caused the weld nut to brake off when putting torque on it. If you have not already installed the other bolts, you will want to clean them out with WD-40 and wire brush…

view full answer...

Answer 2

The likely issue is that when you tighten one bolt down around the bumper beam on the 2014 VW Passat, it loosens up the other side. As time-consuming as it sounds you will need to basically go back and forth tightening each bolt a little at a time…

view full answer...

Answer 3

If a bolt will not torque down while installing a trailer hitch this means the bolt was likely cross threaded. There are a few options to fix this, the first would be drill out and then re-tap the hole with the next largest thread size using a kit…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hi David! There are quite a few hitches offered for your 2026 Honda Odyssey, so I definitely understand wanting to know the differences. There are basically three styles available for you and I have them broken out below: Exposed Crosstube: etrailer…

view full answer...

Answer 7

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Answer 8

Hey Adrian! The higher capacity for the B&W #BW47BR and Curt #C77MJ comes from the construction. The B&W hitch weighs 45 lbs and then the Curt and Trailer Mate #TMT54FR both weigh 32 lbs. The Trailer Mate does sit just a tad higher compared…

view full answer...

Replacement Hardware for a Curt C13397 Hitch

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching