Lift Kit For Avan Aliner With Torsion Axles

Question

Question:

Hi, Do you have a 2 5/8 lift kit available for an Avan Aliner with AL-KO torsion bar suspension. Regards

asked by: Tom V

0

Expert Reply:

For a torsion axle such as your Avan Aliner we have kits available that will give you some extra clearance.

The Avan Aliner is a single axle trailer, so we have two kits that will work for you. Torsion axles must be side-mounted and not top mounted and can not be used with Torflex axles with 3 inch high profiles.

The first one I recommend is The Torflex Lift Kit - Single Axle - 2-5/8 inch Lift # K71-707-01 which is compatible with #10 Torflex axles with 2,300 to 4,000 pound capacities.

The second kit is The Torflex Lift Kit - Single Axle - 2-5/8 inch Lift # K71-723-01 which is compatible with #9 Torflex axles with a 2,000 pound capacity.

I have attached a review video link below.

expert reply by: Noah E

0

Answer 1

I was unable to find a reference to your axle; is it a torflex axle or standard axle?

view full answer...

Answer 2

Hey Pete, thanks for the information! You most likely need the #10 Torflex Lift Kit item #K71-707-01 you were looking at but there is a chance you have a different axle so I'd like to verify. If you could send me a picture of your axle tag or…

view full answer...

Answer 3

Hey Ingo, in the past we have had customer with a 2017 Aliner camper similar to yours verify that they had Dexter 2,500 Torflex axles like what the Dexter lift kit part #K71-707-01 fit. Now this kit can't work with the 3 inch high profile…

view full answer...

Answer 4

From what I can see in the photo it looks like you have a Dexter Torflex torsion axle, the #10 Torflex axle with a 2,500 lb capacity. Based on that the correct lift kit is the Torflex Lift Kit #K71-707-01. However, it is important to make sure your…

view full answer...

Answer 5

Hey Ron, yes the Dexter lift kit part #K71-707-01 that you referenced does fit the Torflex axle you have on your 2017 A-Liner Scout.

view full answer...

Answer 6

Hey Julie, in the past we have had customer with a 2017 Aliner camper just like yours verify that they had Dexter 2,500 Torflex axles like what the Dexter lift kit part #K71-707-01 fit. Now this kit can't work with the 3 inch high profile…

view full answer...

Answer 7

Hey Ken, A 2015 Aliner Expedition should have a 3,500lb axle, which should have a 2-3/8" diameter axle tube. If this is true then you can use the Dexter Trailer Springs Over-Under Conversion Kit #K71-384-00 to raise the trailer height. This is…

view full answer...

Answer 8

I attached a picture that shows the dimensions of the Dexter lift kits #K71-723-01.

view full answer...

Answer 9

Hi Thomas; it looks like the old 568861 has an inner diameter of 1.719" and outer diameter of 2.565". I recommend measuring yours just to be sure. Assuming that is correct, you can use the #RG06-050 which is a pair of seals that share the…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Lift Kit For Avan Aliner With Torsion Axles

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching