Recommended Lift Kit for a # 10 Torsion Axle

Updated 07/31/2025 | Published 07/29/2025

Question:

Looking to buy a 3 lift kit for my 2017 Jayco 17 RB. It has a Lippert 3500lbs single torsion axle installed on it. Could you recommend a specific setup that would work for my application? I Hope you can help and advise. Thanks

asked by: Peter L

Expert Reply:

Hey Pete, thanks for the information! You most likely need the # 10 Torflex Lift Kit item # K71-707-01 you were looking at but there is a chance you have a different axle so I'd like to verify. If you could send me a picture of your axle tag or take a measurement of the bolt spacing that would confirm exactly which one you need.

The # 10 Torflex Lift Kit item # K71-707-01 has a bolt hole spacing of 8" on center. I have a attached a diagram below that will show you where to take the measurement. This is the tallest lift kit we offer for a # 10 torsion axle.

Are you needing additional clearance or is there another reason you're lifting your trailer?

expert reply by: Jerred H

Measurement
(click to enlarge)

Peter L.

7/29/2025

Hello Jerred. I tried to send you a picture of the sticker that’s on the axle and be more the happy to provide you with as much information that I can. Unfortunately your site won’t accept pictures. Can you provide me with either a phone number or an alternative email address, so I can provide that information to you? Also, the reason for me trying to lift the towing setup is, the tow vehicle is a Highlander and by the time you add the sway bars on to it, I’m scraping or get close to that situation that I want to correct. Thanks again for your quick response. Pete

Jerred H.

7/29/2025

@PeterL You're welcome! Just go ahead and send that picture to the email address you receive this response from.

Jerred H.

7/29/2025

@JerredH Thank you so much for the picture! I just spoke with Lippert and you have a diamond torsion axle which we do not have a lifting block for. The pn you need is 270682 though. Hopefully you can use this information and source a set elsewhere. Let me know if you have any additional questions down the road.

Peter L.

7/29/2025

Hello Jerred, do you know if there is any prints available for this 270682 kit? Thanks Pete