What Replacement Mounting Bracket do I Need for My 7-Way Vehicle Plug?

Question

Question:

I need to replace the mount for the connector between the trailer and my 2016 Nissan Frontier wiring harness. I attached a photo.

asked by: Joe Z

0

Expert Reply:

Thanks for the photos! For a great replacement bracket, I recommend the EZ Connector Mounting Bracket for 7-Way Trailer Connector - Vehicle End # 319-S7-61. The advantage of this bracket is that it comes with the bolts included where most other brackets do not.

If you are looking for a no-drill solution, I suggest using the no-drill mounting bracket # 18136 in addition to the # 319-S7-61.

I went ahead and attached a super helpful installation video that show show to use these components.

expert reply by: Bob C

0

Neighbor's Broken 7-Way Bracket
(click to enlarge)

Answer 1

Hey Rogelio, thanks for reaching out. It is totally fine to use a no-drill bracket like part 18140 on a hitch with a square crosstube. People do it all the time and it works out fine. It's basically a hose clamp and once you tighten it, it can…

view full answer...

Answer 2

If you were to install the Curt Trailer Hitch Receiver #C13309 on your 2017 Nissan Pathfinder then you would need to mount the Curt T-Connector #C56357 directly to your rear bumper fascia using the mounting bracket #PK12711U. To avoid this you can…

view full answer...

Answer 3

Hey Emiliano, What you're needing is the Curt T-Connector Vehicle Wiring Harness #C56431. This is a simple plug-in installation just behind the driver's side of your back bumper and it enables you to have a fully-functional 7-Way like…

view full answer...

Answer 4

The difference between the Curt #14211 and the Curt #C14008 is pretty subtle, but it has to do with how they mount to the frame of the vehicle. The Curt #14211 mounts in factory drilled holes further forward in the frame allowing it to fit on a 2003…

view full answer...

Answer 5

First you will want to connect an 18 gauge wire to the Temp Sender mounted on your vehicle. You will then route the wire through the firewall into the passenger compartment where the Temperature Gauge is mounted and attach the Temp Sender wire to the…

view full answer...

Answer 6

Hey Emily, the Blu Technology RV Pressure Regulator #GB97FR uses the standard 1/4 inch quick disconnect size that is the same as what you would see on an air compressor. Do you have a compressor you could compare to the larger size you have?

view full answer...

Answer 7

Hi Jim, good question, and you’re on the right track with your thinking. Electrical issues like that aren’t at all common with the Roadmaster Nighthawk #RM-676, but what you’re describing does line up with a backfeed or short, not a failure of the…

view full answer...

Answer 8

Hey Kurt, We sure do! I've linked below the video of Ryan installing the Curt #C47HR (That is our part number for the Curt #13459) being installed on a 2022 Subaru Forester for you to check out. What are you planning on using your hitch for?

view full answer...

Answer 9

With Curt Trailer Hitch Receiver #C15302 installed on a 2003 Chevy Silverado 2500 short bed the hitch will be in the same position as a factory hitch or at least within a fraction of an inch. By that I mean the receiver will be right under the rear…

view full answer...

What Replacement Mounting Bracket do I Need for My 7-Way Vehicle Plug?

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching