Recommended Trailer Valet for 5,000 Pound Trailer on Sloped Driveway

Question

Question:

I have a trailer that weighs less than 5,000lbs and I have a driveway that lowers around 5-7 degrees into my backyard where I store it. Is there a trailer valet that works for me, so I can take it down my driveway safely. Thank you for the help.

asked by: Matt

0

Expert Reply:

In order to take your trailer down your driveway I recommend the Trailer Valet RVR5 Remote-Controlled Trailer Dolly - Wireless Remote - 5,500 lbs # TVRVR5. However, you will need to find out the actual slope in order to verify if this will work for you.

The instructions state " DO NOT use the RVR on slopes and inclines exceeding a strict maximum of 5 degrees on a paved/concrete surface." If it is 5 degrees or less you will be able to use this without any issues. If it exceeds 5 degrees then you will not be able to use the RVR for your trailer.

In terms of capacity this will not have a problem handling your trailer. The RVR has a tongue weight capacity of 550 lbs and weight capacity of 5,500 lbs. This also requires a minimum tongue weight of 165 lbs.

I have attached a review video for your reference.

expert reply by: Robin H

0

Answer 1

The Trailer Valet RVR3 Remote-Controlled Trailer Dolly - Wireless Remote - 3,500 lbs #TVRVR3 you referenced has a tongue weight capacity of 350 lbs max. The mounting bracket with attach directly to your trailer tongue and has a quick release cotter…

view full answer...

Answer 2

Since there isn't an adapter for the Lock N Roll articulating couplers you wouldn't be able to use the part #TVRVR9 but you could use the Trailer Valet RVR3 part #TVRVR3 instead which instead attaches to the frame of the trailer. This…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 8

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Recommended Trailer Valet for 5,000 Pound Trailer on Sloped Driveway

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching