For your trailer and situation I recommend the Trailer Valet RVR12 Remote-Controlled Trailer Dolly #TV59FR. This dolly is rated for trailers with a tongue weight up to 1,200lbs and a trailer weight up to 12,000lbs. Your trailer has a maximum trailer…
If you only have 1/8 to 1/4 inch of space to close your garage the Trailer Valet you'd need is the part #STC-V211 which attaches to the frame of the trailer because of that would not add additional length to your trailer which would reduce your…
The Trailer Valet XL Trailer Dolly with Chain Drive - 2-5/16" Hitch Ball #TVXL25 actually has a 10,000 lb trailer weight capacity and 1,000 lb tongue weight capacity. It is very likely that your 20 foot travel trailer will have a weight that is…
Yes, the Trailer Valet RVR9 Remote-Controlled Trailer Dolly #TVRVR9 will climb a loading ramp like the #288-07432 into the back of your truck. I confirmed this with Trailer Valet to ensure that it did not have an out of level sensor that would stop…
As long as your truck doesn't have a body lift, meaning the bed is further away from the truck's frame than stock, you should be fine. The B&W Companion 5th Wheel Trailer Hitch w/ Slider #BWRVK3400-5W with the installation kit…
Thanks for reaching out! The purpose of the Trailer Valet Trailer Wheel Dolly for Tandem Axle Trailers #TV56FR is to give you better maneuverability with a tandem axle trailer when utilizing a trailer dolly like the Trailer Valet XL #TVXL25. The…
Yes, you can switch from the 2-5/16" hitch ball to a 2" hitch ball with the Trailer Valet XL Trailer Dolly with Chain Drive - 2-5/16" Hitch Ball - 10,000 lbs #TVXL25. All you will need is the 2" Hitch Ball w/ Base for Trailer…
That is correct. There is nothing to support the bumper when you install the Curt Hitch item #C15398 on a 2013 Toyota Tundra. That hitch was designed for the trucks without the factory hitch so there's no reason for it to have built in support…
Yes, you can! We've spoken to Curt about this exact issue before and we do have a solution. The Curt Hitch item #C15398 is designed for the 2013 Toyota Tundra's that come without a factory hitch. However, it will fit the Tundra's that…
We have a help article that covers how to test to see if trailer brake magnets are bad that I attached to this page. You'll need a multimeter like part #PT29ZR and access to a car battery.
Most trailer hitch balls have a flat part on two sides of the base like the 2" Hitch Ball - 1-1/4" Diameter x 2-5/8" Long Shank - Chrome - 10,000 #A-90 for example. You will simply need a open end wrench large enough to fit that. Vise…
The closest grease caps we have available to the 2.04 inch hub bore diameter you provided are the Bearing Buddies #BB2047. These are designed for 2.047 inch hub bores so they should work great. They will replace the existing grease caps and provide…
Filter Results
