Should MORryde Equalizer Kit MR87ZR Or MR27ZR Be Used With 35" Axle Spacing?
Published 01/31/2022 >
Products Featured in This Question
Question:
I have Jayco 29RLDS with 2 4400lb. axles. I ordered wet bolts/shackles and MR87ZR. My axles measure 35inch center to center. My FHS measurement is 58 3/4. Did I the right equalizer or should I have 35inch MR27ZR. I think my springs are 26inch end to end. I have already installed these.
asked by: Steve J
Expert Reply:
As your axles measure 35" apart from center to center but the frame hanger spread (FHS) measured 58-3/4", you did go the correct way. The axle spacing is definitely important, but the FHS is more so. Just be aware that you axle spacing may change a little due to the MORryde Rubber Equalizers # MR87ZR being shorter than the # MR27ZR (quick diagram included), but this will be perfectly fine.
Product Page this Question was Asked From
MORryde Rubber Equalizers for Tandem Axle Trailers - 33" Wheelbase - 8K
- Trailer Suspension Parts
- Equalizer Upgrade Kit
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- 6-1/2 Inch Long
- Tandem Axle
- MORryde
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Search Results: trailer suspension parts
- Shop: MORryde Shock Absorbing Suspension Equalizers for Tandem Axle Trailers w/ 35" Wheelbase - 8K
- Shop: Lippert Standard Replacement Shock - Black
- Shop: Replacement Dexter Bolt-On Shock Kit for 2-3/8" or 3" Diameter Axle - Single Axle
- Video: In-Depth Review of the Tandem-Axle Trailer Hanger Kit for Double Eye Springs
- Shop: MORryde Rubber Equalizers for Tandem Axle Trailers - 33" Wheelbase - 8K
- Shop: MORryde Shackle Upgrade Kit for Triple Axle Trailers w/ LRE Leaf Spring Suspensions
- Shop: Front/Center/Rear Hanger for Double-Eye Springs - 3-5/8" Tall - 9/16" Bolt Hole
- Shop: Dexter E-Z Flex Suspension Kit - Double-Eye Springs - Tandem Axle - 6,000 lbs
- Search Results: suspension enhancement
- Article: How to Measure a Trailer Axle
- Search Results: trailer leaf springs
- Search Results: shocks trailer suspension parts
- Search Results: trailer shock kit
- Q&A: How to Determine Correct MORryde CRE3000 Equalizer Upgrade
- Q&A: Determining Correct MORryde CRE3000 Equalizer Kit For 2019 Heartland Fuel 352 5th Wheel Trailer
- Q&A: How to Pick Out MORryde Equalizer Kit If Wheelbase is 34 inches
- Q&A: Recommended 7000lb Leaf Springs To Replace Dexter 072-027-00
- Search Results: brass bushings
- Q&A: Could MORryde Equalizer Kit MR27ZR Fit 2015 Northwood Artic Fox 35-5Z
- Q&A: Will MORryde Rubber Equalizers MR27ZR Raise A Trailer?
- Search Results: dexter trailer suspension parts
- Q&A: Recommended Shock Absorbers On 5th Wheel Trailer For More Comfortable Towing Experience
- Video: Review of MORryde Trailer Leaf Spring Suspension - Equalizers - MR27ZR
- Video: Detailed Breakdown of the MORryde Rubber Equalizers for Tandem Axle Trailers
- Video: 4-Leaf Double-Eye Spring for 4,000-lb Trailer Axles Spec Review
- Video: In-Depth Review of the Replacement U-Bolt with Nuts for 2-3/8" Round Trailer Axles
- Video: Replacement 6-Amp Auto Reset Breaker for Lippert Power Stabilizer Jack: The Breakdown




