Correct Liftgate Lift Support for a 1997 Toyota 4Runner

Question

Question:

What is the diameter? To fit a 1997 4-Runner SR5

asked by: Bruce

0

Expert Reply:

The correct Liftgate Lift Support for a 1997 Toyota 4Runner is part # ATL98VR.

expert reply by: Conner L

0

Answer 1

When the manufacturer tests the fit of a hitch like the Draw-Tite #75091 they do not test for larger spare tires. From what I have found, the #75091 is about the same as the OEM hitch and leaves very little room for your typical spare tire. That…

view full answer...

Answer 2

I have a few different options for you, but the Draw-Tite Receiver #65041 is not going to fit a 1998 Toyota 4Runner. If you want to stick with the Draw-Tite brand, I recommend going with the Max-Frame Hitch Receiver #75091. It is a Class III hitch,…

view full answer...

Answer 3

Yes, we do sell the installation hardware for the Curt trailer hitch receiver #C13087. Use part #RHK and then select "Curt" from the drop down and enter the part number. This will order the exact hardware that is included with a new hitch.

view full answer...

Answer 4

The Draw Tite Hitch part #75091 is confirmed to fit your 2001 Toyota 4Runner and we had a customer write in a review saying that this hitch installs without any interference with the factory spare tire. The instructions for this product indicate that…

view full answer...

Answer 5

I attached a picture that has the install instructions for the Curt hitch #C13087 that you have as well as a link to them on this page as well. Sometimes the instructions are stuffed down the hitch tube opening which can make them harder to find.

view full answer...

Answer 6

I may have an alternate option available that will require drilling to get installed, but with your 1996 Toyota Prado not being an American market vehicle, I cannot confirm the fit of any hitch we carry. I did include diagrams for the Curt #13445 and…

view full answer...

Answer 7

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 8

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 9

Hello Joe, Thank you for reaching out! The Power Mountain Tallboy Off-Road Bottle Jack - 11-5/16" to 27-1/16" Lift - 12 Tons #PM94FR does have the capacity you’d need, but since your fifth wheel’s frame sits about 25" off the ground,…

view full answer...

Answer 10

Hey Tom, great question! Both products provide an easy way to measure tongue weight, but they excel in different situations. The BTBRV Trailer Jack Foot Scale #BTBRV014 measures tongue weight at the trailer jack, so you don't need to position a…

view full answer...

Answer 11

Hi Hilario, congrats on the new truck! ^___^ If this were my truck and I was installing a retractable cover on it (which I actually did with my Silverado), I would go with the manual RetraxPRO XR Hard Tonneau Cover - Retractable - Aluminum - Matte…

view full answer...

Correct Liftgate Lift Support for a 1997 Toyota 4Runner

Product Page this Question was Asked From

Continue Researching