Does the TorkLift StableLoad # TLA7200 Require Drilling for Installation on My 2022 Ford F-250?

Question

Question:

Does the torklift stableload suspension TLA7200 require drilling on my 2022 ford f-250 super duty?

asked by: Eric K

0

Expert Reply:

I am happy to report that the TorkLift StableLoad Suspension Upgrade # TLA7200 does not require drilling on your 2022 Ford F-250 super duty. I went ahead and attached a photo of from the instructional manual for you to check out.

It is important to note that you will need to have the factory-installed upper overload bump stop bracket in order for the StableLoad to install and function properly.

expert reply by: Bob C

0

TorkLift StableLoad # TLA7200 Installation Instructions
(click to enlarge)

Answer 1

Hey Rick! For your 2026 Ford F-350 Super Duty with 4WD, you will go with Hellwig Adjustable Big Wig Rear Anti-Sway Bar - 1-5/16" Diameter #HE94FR. This model is intended for 4-wheel drive models that sit at stock height. The Hellwig Adjustable…

view full answer...

Answer 2

Hey, Devan. Thanks for your question. I completely understand wanting that confirmation. As of right now, the only pin box confirmed to not void the Lippert frame warranty is the Curt Helux, part #C73RJ. However, the Helux pin box is only compatible…

view full answer...

Answer 3

Hey Jacqueline, thanks for reaching out! The TorkLift GlowStep Camper Scissor Steps #TLA7804 can be left on permanently, but they also have some simple pins that keep them in place in case you ever wanted to take them off and store them elsewhere or…

view full answer...

Answer 4

The correct set of TorkLift StableLoad Rear Suspension Upgrades for a 2015-2020 Ford F-350 is part #TLA7310 for the lower overload (if equipped) and part #TLA7200 for the upper overload (if equipped). There should be both an upper and lower overload…

view full answer...

Answer 5

A lot of people will just mount a tool box like the DeeZee Red Label Truck Bed Tool Box #DZ8546 or Buyers Products Utility Storage Box #3371712230 to the bottom rails of the 24x60 etrailer Cargo Carrier for RV Bumper #e99049 for lockable storage…

view full answer...

Answer 6

Hey Evan, thanks for reaching out! The TorkLift GlowStep Camper Scissor Steps #TLA7504 measure 22" at the widest points - I confirmed this with my contact at TorkLift.

view full answer...

Answer 7

Welcome back, Ted. My sons name is Ted too (after Theodore Roosevelt), so you are easy to remember :) So the MORryde Cushioned 5th Wheel Pin Box #MR74VR does not come with bolts. Generally folks will reuse the original bolts, but if you need a new…

view full answer...

Answer 8

From the looks of the photo you have attached it appears you have a lower overload spring, not an upper overload spring that is required for the TorkLift StableLoad Suspension Upgrade for Upper Overload Springs part #TLA7200 to work. This kit will…

view full answer...

Answer 9

Good question, Todd! I spoke with Air Lift and the LoadLifter 7500 XL #AL83DQ will have no issues working on a 2025 Ford F350 Crew Cab Dually with the FX4 package. Have you considered an sir compressor system as well? They aren't completely…

view full answer...

Answer 10

The auxiliary 12-volt wire that runs from the 7-way connection to 7-way trailer plug will supply 12-volt power from the vehicle to the trailer. The 12 -volt power will allow interior or exterior lights to run that are not wired in to the…

view full answer...

Answer 11

The TorkLift StableLoad Suspension Upgrade Kit #TLA7200 works on both 2WD and 4WD versions of the 2019 F-350 that has a factory leaf spring suspension and an upper overload spring. These rubber block springs replace the truck's factory bump stop…

view full answer...

Answer 12

The thickness of the #TLA7200 block itself is 2.25" in height. The height of the anti rock plate is 9/16" in height.

view full answer...

Does the TorkLift StableLoad # TLA7200 Require Drilling for Installation on My 2022 Ford F-250?

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching