What Does Hitch Not Rated for Use with Weight Distribution Mean for a Trailer Hitch

Question

Question:

What does it mean when it says this product has not been rated with weight distribution

asked by: Brad

0

Expert Reply:

A trailer hitch that is not rated for use with weight distribution means that the hitch cannot be used with any type of weight distribution system because of its bracket design (short brackets on this hitch) and they could have also found in testing that it does not hold up well with weight distribution. This hitch is also made for cab and chassis models of the 2003 GMC Sierra so if you have a regular pickup this hitch will not fit.

If you do have a cab and chassis model then Curt trailer # C15400 can be used with weight distribution. I have included a link to the installation instructions for you. I also recommend the etrailer ball mount kit # EBMK2416. It comes with a ball mount, 2 balls, a hitch pin with clip, and a storage bag.

If your truck did not come with trailer wiring you can use # HM40975.

expert reply by: Michael H

0

Answer 1

I would be happy to help you get set up with all of the components you will need to tow an ultra lite RV trailer with your 2014 Honda Odyssey. Starting with the trailer hitch receiver the Curt Trailer Hitch Receiver #C13068 is a great option which…

view full answer...

Answer 2

For your 2007 Dodge RAM 3500 HD Flat Bed Crew Cab with dually chassis there is not a B&W trailer hitch receiver available. Instead, I recommend you use the Draw-Tite Ultra Frame Trailer Hitch Receiver - Custom Fit - Class IV - 2" #41936…

view full answer...

Answer 3

Hey Michael, We have some hitch options available but I'll need a bit more information on your Silverado in order to find the correct fit. The available hitches are sectioned out by model (1500, 2500, 3500), bed length, and bumper type. If you…

view full answer...

Answer 4

Hey Ryan, the hitch design of the GM hitch you have is pretty standard so I would assume a hitch hardware kit for a hitch like the Curt part #C15302 would work just as well if you were to order it's hardware with the part #RHK. That said, best…

view full answer...

Answer 5

While we haven't had the opportunity to install the Curt #C15809, Curt #C15704, and Draw-Tite #DT45509 hitches, from what I could see in the photos customers have sent in it looks like the Draw-Tite will actually sit right up next to the bumper…

view full answer...

Answer 6

I have attached an image of the Draw-Tite Hitch item #41947 referenced in your question with a few dimensions labeled. The distance between mounting holes, from the left side mounting bracket to the right side mounting bracket is 30-1/2". The…

view full answer...

Answer 7

From side to side, the mounting holes measure 31-1/4 inches apart, center to center. All three sets of holes are the same distance apart. From rear to front, beginning at the rear of the vehicle the distance from the first set of holes to the second…

view full answer...

Answer 8

I do have some great trailer hitch options for a 1997 Chevrolet C3500 though none are designed for use with service bodies. That said, we do have options for models with a drop tube bumpers which would be the best option for models with service…

view full answer...

Answer 9

Sounds like your brake controller will apply your trailer brakes if you apply the manual override lever but not when you press the brake pedal. This is a fairly common problem and the solution is the red wire of the brake controller. Make sure it is…

view full answer...

What Does Hitch Not Rated for Use with Weight Distribution Mean for a Trailer Hitch

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching