Replacement Locking Knob Shaft for MaxxAir MaxxFan RV Roof Vents

Question

Question:

when turning the black knob, the vent housing will not open, like a piece is stripped out. are there replaceable parts for the opening knob operation?

asked by: Terry C

0

Expert Reply:

We do have the Replacement Locking Knob Shaft for MaxxAir MaxxFan RV Roof Vents, # MA10-21232KSHAFT.

expert reply by: Michael R

0

Replacement Locking Knob Shaft for MaxxAir MaxxFan RV Roof Vents_MA10-21232KSHAFT
(click to enlarge)

Answer 1

Hey Stanley, it does sound like you are in need of a replacement operator for your Maxxair 7500k which we offer with the part #MA10-20281K-1AF.

view full answer...

Answer 2

The two most likely causes of a MaxxAir vent fan lid not opening or closing are either going to be a lift motor or operator failure. I recommend removing the motor and applying power directly to this to see if the shaft turns. If not, you know the…

view full answer...

Answer 3

The best fitting tow mirrors available for your 2023 Jeep Gladiator would be the K-Source mirrors part #KS39NQ which are custom fit for the factory mirrors of your vehicle. The CIPA mirrors you mentioned would work but they are universal fit so they…

view full answer...

Answer 4

We've spoken with Furrion about your same issue with another customer and they informed us that the 88 error code on your Furrion fireplace means the blower fan is overheating. You want to make sure the inlet and outlets of the fireplace are free…

view full answer...

Answer 5

We have the Universal RV Drawer Slide Kit #37270995 which comes with a single 22" long track and includes the mounting screws. This is a universal style slide kit. It is not the 24" you currently have but can be used as a replacement…

view full answer...

Answer 6

Per conversation with Lippert, the Lippert Components Tuson High Speed 5th Wheel RV Landing Gear Motor #LC141893 is a compatible replacement for the 1-065-041012-01 electric motor you listed.

view full answer...

Answer 7

Given the issue you described and the fact that you have done a good job of troubleshooting and checking other potential sources for the issue, it sounds like the motor is going bad. Since you mentioned the landing gear working fine for a little bit…

view full answer...

Answer 8

When installing the #MA10-20281K-1AF replacement operator, you might need to 'clock' the mechanism slightly which could take a little bit of trial and error, but the replacement operator does include installation instructions. I've…

view full answer...

Answer 9

In this senario, I would run a wire from the center pin of the 7-way to the reverse light circuit on your truck. This will enable you to bypass the fuse. Because of this direct connection you should be able to back up without your trailer brakes…

view full answer...

Answer 10

There are not installation instructions available specific to the Replacement MaxxAir Roof Vent Manual Lift. I have attached an exploded diagram that shows the placement of the lift in the fan assembly for your reference.

view full answer...

Answer 11

Hey Patricia, it shouldn't be that difficult to open the lid so I would look for something that's possibly interfering or a damaged component. Does the knob just turn or does it not want to move either? The operator mechanism part…

view full answer...

Answer 12

Great question! I contacted Maxxair and the Replacement Locking Knob Shaft Item #MA10-21232KSHAFT is in fact compatible with your MaxxFan Roof Vent Item #MA00A04401K.

view full answer...