Recommended Ceiling Garnish Compatible with MaxxAir Roof Vent 4501K

Question

Question:

Hey guys which garnish ring will fit a max fan 4501k? Application- 2021 Renegade 45 CME Thanks

asked by: Pete W

1

Helpful Expert Reply:

The ceiling garnishes like the MaxxAir Maxxfan RV Roof Vent - White item # MA54FR you were looking at are universal. So long as you have the standard 14"x14" opening for your MaxxAir 4501k this garnish will be able to fit. It may require some trimming to match your ceiling depth.

expert reply by: Jerred H

1

Pete W.

11/11/2021

Thanks Jerred for your help. My garnish ring is 16 1/4 x 16 1/4 from outside edges and the inside edge is approximately 13 1/2 x 13 1/2 . This measurement is installed and looking at the ceiling. Will the MA54FR still work? Thanks again

Les D.

11/15/2021

@PeteW Yes the MA54FR will work.

Answer 1

Hello Mark, welcome back. The MaxxAir II RV and Trailer Roof Vent Cover #MA76JR is compatible with your MaxxFan #4751K. It may not be tall enough for the vent lid to open fully, but as long as the lid is 50% open you will be getting maximum airflow…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 4

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Thanks for the picture! I checked with Progressive Dynamics the replacement power converter you need for your Parallax Series 7300 Model 7345 is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp item #PD4645V.

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Recommended Ceiling Garnish Compatible with MaxxAir Roof Vent 4501K

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching