Spacers for Timbren Suspension Enhancement System on 2022 Ford F-350
Published 10/28/2021
Products Featured in This Question
Question:
I purchased from etrrailer and installed the Timbren Suspension Enhancement System for the rear axle, part number TFRTT350J on a 2022 Ford F350 . There is a gap between the jounce stop and axle contact point greater than I expected for when no load is on the truck. The instructions state "There should be a ½” to 1 ½” gap between rubber spring and axle to ensure unloaded ride quality". I also see that this larger gap spacing is not that uncommon from reading online forums. Many are suggesting that you can easily resolve this issue using taller or additional spacers. My question is, can you stack these? My gap is a little over 2' so I need about 1 ½” of spacer thickness.
asked by: Trevor
Expert Reply:
Yes, you can stack the 1 inch spacer, # A25723-90AH00 and the 1/2 inch spacer, # TA25723-90AD00 but you will most likely need to replace the hardware too. I suggest you source this locally, purchase Grade 8 hardware, and simply buy one 1-1/2" longer than current bolt.
Product Page this Question was Asked From
Timbren Suspension Enhancement System - Severe Service - Rear Axle
- Vehicle Suspension
- Towing/Load Leveling
- Bump Stops
- Suspension Only
- Extra Heavy Duty
- Rear Axle Suspension Enhancement
- Timbren
more information >
Featured Help Information
Instructions
Continue Researching
- Search Results: axel flip kit
- Search Results: timbren
- Search Results: timbren spacers
- Search Results: rv and camper bike racks
- Shop: Suspension Enhancement
- Shop: Swagman Stratus Bike Rack for 2 Bikes - RV Frame Mount
- Shop: Spacer Kit for Timbren Suspension Enhancement System
- Q&A: What Causes a Trailer to Bounce/Porpoise on Highway
- Shop: B&W Anti-Rattle Clamp for 2-1/2" Hitch Receivers
- Video: How to Install: TorkLift SuperHitch Magnum Trailer Hitch Receiver on your 2022 Ford F-350 Super Duty
- Shop: Stromberg Carlson RV Jack Pads for 2,500-lb to 9,000-lb Scissor Jacks w/ Bowtie Bases - Qty 2
- Q&A: Can a Trailer Ride With the Tongue at an Upward or Downward Angle
- Shop: Vehicle Tow Bar Wiring
- Q&A: Solution for Replacement Swing Away Tongue on ShoreLand'r Boat Trailer
- Q&A: Does The Built-In Bed Step Affect Fitment Of Camper Tie-Downs On A 2023 Ford F-350 Dually
- Q&A: How to Unplug a 7-Way Harness from the 7-Way on a Ford Super Duty
- Shop: TorkLift Locking FastGun Turnbuckles for Frame-Mounted Tie-Downs - Polished Stainless Steel - Qty 4
- Q&A: 7-Way Wiring Configuration for Slide-In Truck Camper
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Shop: TorkLift AnchorGuard Derringer Turnbuckles for Truck Camper Tie-Downs - Stainless Steel - Qty 4
- Shop: HappiJac Qwik-Load Turnbuckle Set for Flatbed Truck Camper Tie-Downs - Qty 4
- Video: Let’s Check Out the GSI Outdoors Camping Coffee Percolator
- Video: A Closer Look at the Valterra Flushing Hose for RV Sewer System
- Search Results: trailer hitch
- Shop: Trailer Hitch
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Video: Firestone Ride-Rite Air Bags with Easy Mount Compressor Feature Breakdown
- Shop: Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
on Vehicle Suspension
