What All Is Included With The Swagman Replacement Wheel Strap SP494

Question

Question:

Does sp494 include the trap, screw+nut and that little thing that used to press on a rim? Thanks.

asked by: Henry

1

Helpful Expert Reply:

The Replacement Wheel Strap for Swagman G10 and Quad 2+2 Bike Racks # SP494 will indeed include the strap, rim protector, nut, bolt, and an end cap for the bolt as well so no sharp edges are exposed. These will be all the pieces needed to completely replace a strap on your rack. I included a picture of the package contents as well.

expert reply by: Lazer S

1

Swagman SP494 Package Contents
(click to enlarge)

Answer 1

We have the following replacement parts available for your Swagman G10 bike rack. Replacement Wheel Strap for Swagman G10 and Quad 2+2 Bike Racks #SP494 Replacement Horizontal Cross Bar Set for Swagman G10 2-Bike Platform Rack #SG1030 Fat Tire…

view full answer...

Answer 2

Based on your photo you provided, it looks like you have your current wheel holders installed backwards. The 'high' side of each holder should angle up towards the center mast of the bike rack, while yours appear to be the opposite. On each…

view full answer...

Answer 3

I went ahead and got the measurement for the Replacement Wheel Strap for Swagman Chinook, Dispatch, E-Spec, G10, and Quad Bike Racks #S95YR and measured 17.7165". I also confirmed that this wheel strap is the correct wheel strap for your Swagman…

view full answer...

Answer 4

To replacement the wheel straps on your Swagman Chinook Bike Rack #S64683 you need the kit #SP494 which comes with the strap and everything needed to get it installed.

view full answer...

Answer 5

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 6

The Locking Anti-Rattle, Threaded Hitch Pin for Swagman Hitch Racks #S64029 comes with both the flat washer and the lock washer. I recommend putting the split lock washer on first and then the flat washer then insert the pin into the hitch. This will…

view full answer...

Answer 7

It sounds like you have put the washers on correctly. The one with a slit in it is probably the lock washer. It would go on the side with the threads. A lock washer is designed to help hold the bolt in place so it will not come loose. A flat washer…

view full answer...

Answer 8

To add lights and a license plate holder to your Swagman E-Spec Bike Rack for 2 Electric Bikes #S94FR you'll need the Thule License Plate Holder for Bike Racks #TH35JV and Curt Auxiliary LED Indicator Lights #C53201. The lights come with a 3M…

view full answer...

Answer 9

Hey Kelvin, sorry for any confusion but the sleeve style pictures of the part #S1008M is what this actually is and what you'd get if you ordered it. I sent an update to have the pictures corrected.

view full answer...

Answer 10

Hello Julian; it sounds like you're referring to the black piece that is attached to the wheel strap #SP494 you were looking at. See the picture below. This is only available with the wheel strap so you will need to order the replacement strap to…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

What All Is Included With The Swagman Replacement Wheel Strap SP494

Product Page this Question was Asked From

Continue Researching