Is It Possible For Reese Sway-Control Bracket To Bend When Making Sharp Turns?
Published 09/24/2021
Question:
I am using this part with the associated sway bar. After many trips, I notice this bracket is bent upward 5-10 degrees. I have always removed the sway bar prior to backing up. Will sharp turns also cause this? What other causes would result in this part bending?
asked by: Brian M
Helpful Expert Reply:
If you make a very sharp nearly jack-knifed turn with friction sway control such as the Reese # 83660 still hooked up it is possible that the system was over extended or compressed too much causing the mounting bracket # RP26003 to be bent.
Ideally you want the trailer to be as straight as possible while using friction sway control as due to its design it can only extend or be compressed so much.
I would check out your sway-bar to make sure that it has no damage, and then go ahead and replace the # RP26003 so that you do not have a potentially compromised bracket.
I included videos of the products mentioned for you to take a look at.
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Trailer Hitch
- Shop: Replacement Pin for Friction-Style Sway Control Systems - Qty 1
- Video: Let’s Check Out the Replacement Pin for Friction-Style Sway Control Systems
- Search Results: accessories and parts
- Shop: Curt Friction Sway Control for Weight Distribution Systems
- Shop: Replacement Sway Control Tab for Weight Distribution System - Weld On
- Shop: Curt Shock Absorbing Towing Kit w Sway Control, Wireless Brake Controller - 2-5/16" Ball - 7.5K
- Search Results: reese friction sway control
- Search Results: anti sway bar
- Search Results: sway bar
- Search Results: hitch cargo carrier
- Q&A: Curt Sway Tab Weld On Position For Ball Mount and Friction Sway Control # 83660
- Q&A: Recommendation for Adding 2nd Friction Sway Control Bar to Trailer
- Shop: EcoHitch Invisi Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Ultra-Fab Dirt Bike Carrier for 2" Hitches - With Ramp - 77" Long - 500 lbs
- Video: Curt Weight Distribution Systems Friction Sway Control Installation - 2011 Forest River R-Pod Travel
- Video: Checking Out the Curt Friction Sway Control for Weight Distribution Systems
- Shop: etrailer Scissor Stabilizer Jack - 24" Lift - 2,500 lbs - Qty 1
- Search Results: camper jacks
- Video: Breaking Down the Lippert Solid Stance RV Step Support Kit
- Video: Curt T-Connector Vehicle Wiring Harness Review C56040
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Trailer Wiring Diagrams
- Search Results: trailer hitch
- Video: Firestone Ride-Rite Air Bags with Easy Mount Compressor Feature Breakdown
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Shop: Trailer Wiring
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: How to Measure for Trailer Hitch Drop
on Accessories and Parts
