Do Yakima Artificial Rain Gutters have to be Positioned in a Certain Place on a Truck Camper Shell

Question

Question:

Hi, I have a 2005 Tacoma 6foot Bed with a Leer Canopy. What is the recommended mounting distance between the forward and rear Yakima artificial raingutters. I am going to bolt these to the canopy but am unsure of the distance between. Does it depend on what other accessory racks may go on top eg. bike rack, cargo box etc or do I just mount them as far a part as possible. Thanks for any suggestions you might have.

asked by: Ryan G

0

Expert Reply:

When mounting artificial rain gutters like # Y08002 to a camper shell, there is no specific distance apart they must be placed. What you will want to look at is where you can mount them (the strongest points on the camper shell would be ideal) and how far apart you need them to mount various items like bike racks, canoes, kayaks, cargo boxes, baskets or any other accessory. Just remember that if you place the bars too far back then items on the roof may hang over the back end too much. Same for the front.

In addition to the rain gutters you will also need rain gutter towers, # Y00101. And you will need crossbars. Crossbars come in various lengths. For 48 inch bars use # Y00408. For 58 inches use # Y00409. For 66 inches use # Y00410.

expert reply by: Michael H

0

Answer 1

The Yakima #Y08002 Side Loader mounting brackets are sold in pairs.

view full answer...

Answer 2

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 3

There are a couple of differences between the two. The JetStream bars like #Y00425 are made of extruded aluminum while the CoreBars such as the #Y00421 you've looked at are constructed of galvanized steel. As you've mentioned, the CoreBar has…

view full answer...

Answer 4

I may have a solution for you, but the Replacement Lid Support for Yakima Cargo Boxes #8880683 will not work to replace the gas strut on your old Yakima Rocketbox. However, even though they don't carry them as a replacement part any longer, my…

view full answer...

Answer 5

The Rack'em Fitz-All Enclosed Trailer Ladder Rack is an easy to mount, fully adjustable system for your enclosed trailer. It has a 400 lb capacity, but you will want to research your trailer's capacity for a system like this and go with the…

view full answer...

Answer 6

The best option we have for a roof rack that would have crossbars 10-12 inches above the roof of the trailer would be with the Rack Em Trailer Ladder Rack part #RA-28 which was designed for enclosed trailers but has the taller towers/feet. There…

view full answer...

Answer 7

The Rack'em Fitz-All Enclosed Trailer Ladder Rack part #RA-28 is currently our best and only option for enclosed trailers. Basically you want this system because the rack attaches to the side of the trailer rather than putting all of the weight…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

Hey Steve, good question. The Yakima SkyLine FX Roof Rack #Y88YD will fit your 2023 Grand Cherokee 4xe with fixed mount points. You’ll still be able to use your sunroof with the rack installed, but Yakima doesn’t recommend opening it when the bars…

view full answer...