Which Harness to Install a Redarc Tow Pro Liberty in a 2021 Ford Ranger

Question

Question:

I own 2021 ford ranger with factory tow. Will wiring harness RED69FR work to wire in controller?

asked by: Toby

1

Helpful Expert Reply:

Yes. In order to install the Redarc Tow Pro Liberty # RED24FR on your 2021 Ford Ranger you'll want to use the Universal Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers # RED69FR. This harness will allow you to hard wire in a Redarc controller on your Ranger.

expert reply by: Erik B

1

Answer 1

Hey Scott! Your 2026 Ford Ranger may or may not have a brake controller port/plug, even with the tow package. There will be four wires coming out of a large wire harness by the driver side firewall, left of the brake pedal, which can be wired to the…

view full answer...

Answer 2

For your 2024 Nissan Frontier I recommend the Redarc Tow-Pro Liberty Brake Controller #RED24FR. I like the Liberty because it is simple, reliable, and looks great in any vehicle. The main unit installs behind the dash, so only the control knob will…

view full answer...

Answer 3

Hey Ken! The correct wiring harness depends on whether or not you have the brake controller port/plug. Some models did not include the plug so you will have to check your 2025 Ranger and see. There should be four wires coming out of a large wire…

view full answer...

Answer 4

Hi Richard! The best brake controllers on the market for your 2023 Ford Explorer XLT are going to be from Redarc. They're super easy to use and set up, and they are very reliable. They are the ones to get. Since you said you will be towing a…

view full answer...

Answer 5

The Redarc Tow-Pro Liberty #RED24FR is the way to go over the Elite #RED44FR as you get the nicer functions of the Elite at a lower price. The Elite has the ability to be the more preferred proportional style of controller as well as a time-delayed…

view full answer...

Answer 6

Factory brake controllers seem to unfortunately be very temperamental and usually quite a bit more expensive that an aftermarket brake controller so I have to recommend going with an aftermarket option. Luckily there is a brake controller port so…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Which Harness to Install a Redarc Tow Pro Liberty in a 2021 Ford Ranger

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching