Will the OEM Trailer Hitch from a 1993 Mercury Grand Marquis Fit a 2001 Ford Crown Victoria
Updated 05/21/2013 | Published 05/18/2013
Products Featured in This Question
Question:
93 mercury marquis 88002 hitch compatible with 2001 ford crown vic? and where do i get replace bolts I trust muffler wont be in way by the ay if I go with the newer style hitch being it is a 2001 ford sedanb
asked by: Leon S
Expert Reply:
I checked up on trailer hitch 88002 and found that it was an OEM hitch put on several vehicles. However, the 2001 Ford Crown Victoria is not one of the vehicles listed as a fit so I do not recommend trying to install it on the Ford.
For a hitch that will fit the Crown Vic the most popular Class III hitch is # 13707. I have included a link to a video showing a typical installation and a link to the installation instructions for you.
I also recommend the etrailer ball mount kit # EBMK4EL. It comes with a ball mount, interchangeable ball set, a hitch pin with clip, and a storage bag. For trailer wiring use # C59236. I have linked instructions for the wiring as well.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 400 lbs TW
- 4000 lbs GTW
- 6000 lbs WD GTW
- 2 Inch Hitch
- 600 lbs WD TW
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Search Results: brake controller
- Video: Installing the Curt Trailer Hitch Receiver on your 2007 Ford Crown Victoria
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Brake Controller
- Shop: Hopkins Plug-In Simple Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Search Results: transmission coolers
- Search Results: trailer brake controller
- Search Results: transmission cooler
- Q&A: Ball Mount with 4 inch Rise Recommendation for Use with Curt Hitch for 2003 Lincoln Town Car
- Shop: Draw-Tite Ball Mount for 2" Hitches - 2-3/4" Rise, 4" Drop - 9" Long - 7.5K
- Search Results: hitch pin
- Search Results: locking hitch pin
- Search Results: 7 way to 4 way
- Shop: Curt Ball Mount for 2" Hitches - 4" Rise, 6" Drop - 14-1/4" Long - 6,000 lbs
- Shop: Tekonsha BRAKE-EVN Trailer Brake Controller - 1 to 4 Axles - Proportional
- Q&A: Transmission Cooler and Suspension Enhancement for a 2011 Toyota Sienna
- Q&A: Transmission Cooler Recommendation for 2011 Chevy Silverado
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Q&A: Replacement Hitch Hardware Recommendation for a 2003 Mercury Grand Marquis
- Q&A: Recommended Trailer Hitch and Wiring for 1999 Lincoln Town Car
- Q&A: Shank Length of Curt C45311 Class III Ball Mount
- Q&A: What Hitch Receiver Will Fit On My 2011 Crown Vic