Replacement Progressive Dynamics Converter PD9160A

Question

Question:

my PD9160A was hooked up to bad power. Fuses are good but no power output. Can it be repaired or buy a new unit ? Is the model PD9160C just a newer unit than PD9160A? THANKS

asked by: Thomas K

0

Expert Reply:

If the fuses are good and there's still no power output it would be time for a new converter which we have an exact replacement with the part # PD9160A. The C version is not an updated version and is not one we carry.

expert reply by: Jameson C

0

Answer 1

The 9160A is no longer available so for a replacement I recommend the Progressive Dynamics PD9200 Series Battery Converter Charger with Charge Wizard #PD9260C. The only real difference between this and your old 9160A is the charging cycle. Since this…

view full answer...

Answer 2

You would need to replace the converter you have now with one that is Lithium battery compatible since that's the battery style you have now and they charge at a higher voltage. For that we have the part #PD9160ALV which is a 60 amp…

view full answer...

Answer 3

Hello Victor, thanks for reaching out. The Progressive Dynamics 9300 Series RV Converter Charger #PD79RR will work great for replacing your WFCO WF-9855 converter. We recommend this model as a replacement quite frequently in fact, since it has the…

view full answer...

Answer 4

It looks like the WFCO 8935 is a 35 Amp converter, so you're not going to be able to install the Progressive Dynamics #PD9245C because it is rated for 45 amps. Adding a higher amp rating converter to your system could potentially cause…

view full answer...

Answer 5

Your older PD9145C charger delivers 45 amps of DC charging power at 13.6 volts DC. (For AGM batteries) This converter/charger requires 725 watts of AC power to operate. It also needs to be on its own AC circuit. The Progressive Dynamics #PD79RR…

view full answer...

Answer 6

Hey Phil, the correct 60 amp converter replacement that is Lithium compatible is the Progressive Dynamics part #PD79RR. This charges at the higher voltage required by lithium batteries.

view full answer...

Answer 7

To change the battery mode on the Progressive Dynamics 9300 Series RV Converter Charger #PD79RR you'll need to insert the included CLAW tool into the small opening next to the battery type indicator light. Press and hold that button (using the…

view full answer...

Answer 8

A 15 amp breaker/circuit can be used with the Progressive Dynamics 9300 #PD79RR. It does not require a 20 amp outlet.

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Replacement Progressive Dynamics Converter PD9160A

Continue Researching