What Correct Replacement Tarp Do I Need for My TruXedo Tonneau Cover on My 2008 Toyota Tacoma?  

I may have a solution for you, but it will be difficult to confirm a correct replacement TruXedo Tonneau Cover for your 2005 Toyota Tacoma without identifying information such as a model number. I do show a few TruXedo Tonneau Covers that are…

The replacement tarp part #TX1117750 is the correct replacement tarp for a Lo Pro Tonneau for a 2009 Toyota Tacoma with a 6 foot bed since this tarp fits the part #TX556901 which fits your truck.

We carry so many varients of tonneau covers for the different vehicles. The options we carry for your 2005 Toyota Tacoma would be the TruXport, Lo Pro or the Deuce 2. Of those three, we have one replacement tarp and that is the replacement tarp for…

If you have a Truxedo Low Pro QT tonneau on your 2008 Toyota Tacoma with a 6 foot bed you would have the cover part #TX556901 and would need the part #TX556901-CVR as a replacement.

We have exactly what you need. To replace the cover for your TruXedo Lo Pro Tonneau Cover #TX555901 on your 2005 Toyota Tacoma, you will use the Replacement Cover #TX5559-CVR. This will replace just the cover on your system and will work with your…

I attached a picture that shows the clamp brackets of the TruXedo TruXport Soft Cover part #TX255801 that you referenced. If your bed liners comes up underneath the bed rail then you would just need to trim it so that the clamp can fit it.

It sounds like you have the TruXedo Lo Pro Soft Roll-up Tonneau Cover part #TX556901 on your 2008 Toyota Tacoma with 6' bed and in which case you'd need the Replacement Cover for TruXedo Lo Pro Soft, Roll-up Tonneau Cover part #TX5569-CVR.

I contacted the manufacturer with the date code that you were able to provide and they were able to tell me that the correct replacement tarp/vinyl for the cover on your 2009 Toyota Tacoma with 5' bed is the Replacement Tarp for TruXedo Lo Pro…

The Replacement Tarp for TruXedo Lo Pro Roll-up Tonneau Cover #TX1117750 is the correct replacement tarp if the cover on your 2011 Toyota Tacoma is the 556801 cover. There is also the Replacement Cover for TruXedo Lo Pro Soft, Roll-up Tonneau Cover…

My Truxedo representative recommends using hot water, car wash soap and a soft bristle brush to remove that sap. It's going to take some elbow grease, but that should remove it. Once you have the sap removed, Truxedo recommends using their…

The Craftec Hatch-Style Tonneau Cover, part #352128 is a one-piece lightweight tonneau cover, and has two hidden latches at the rear so you will not have a problem with it flapping in the wind when installed on your 2000 Dakota. The tonneau cover…

The part number on that sticker in your photo refers to the tensioning device, but luckily that narrowed things down enough to determine that the #TX1115174 Velcro strip is the correct replacement for you. It's longer than you actually need, but…