Can Ultimate Trailer Jack 322-RDJ-2K Be Completely Removed From Mounting Bracket?
Updated 07/23/2021 | Published 07/22/2021 >
Question:
Can you remove the shaft entirely?
asked by: Brian D
0
Expert Reply:
Yes, the Ultimate Trailer Jack - A-Frame - Topwind - 27-1/2" Lift - 2,000 lbs # 322-RDJ-2K you were looking at can be removed from the mounting bracket by removing the keeper pointed out in the included diagram, and then removing the foot.
After that you can just lift up and remove the jack from the base.
I included a video review of the # 322-RDJ-2K for you to take a look at.
expert reply by:
Samuel C
0
Product Page this Question was Asked From
Ultimate Trailer Jack - A-Frame - Topwind - 27-1/2" Lift - 2,000 lbs
- Trailer Jack
- Utility Trailer
- A-Frame Jacks
- Topwind Jack
- 1001 - 2000 lbs
- Manual Jack
- 28 Inch Lift
- Bolt-On
- Weld-On
- With Rectangle Foot
- Ultimate Jack
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Video: A Closer Look at the Ultimate Trailer Jack
- Shop: Ultimate Trailer Jack - A-Frame - Topwind - 27-1/2" Lift - 2,000 lbs
- Shop: Square Direct Weld Jack w/ Footplate - Drop Leg - Sidewind - 28-7/8" Lift - 7,000 lbs
- Shop: Trailer Valet JXS Drill Powered Drop Leg Trailer Jack w/ Footplate - Sidewind - Side Mount - 1.8K
- Shop: Ark Xtreme Off-Road Swivel Trailer Jack w/ 2 Wheels - Sidewind - 12" Lift - Zinc - 770 lbs
- Q&A: Which Wheel Caster Can be Used with Ultimate Trailer Jack # 322-RDJ-2K
- Search Results: removable trailer tongue
- Search Results: low profile trailer jack
- Search Results: trailer hitch ball mount
- Shop: SumoSprings Solo Custom Helper Springs - Rear Axle
- Q&A: Shank Length of Curt C45311 Class III Ball Mount
- Video: Checking Out the etrailer Trailer Jack Removable 6" Caster
- Video: Comprehensive Review: Ultimate Trailer Jack
- Video: Let’s Check Out the Removable 6" Caster for 2-1/4" Trailer Jacks
- Search Results: ultimate jack trailer jack
- Search Results: bulldog trailer jack
- Search Results: trailer jack
- Shop: Replacement Caster Wheel for Ultra-Fab Manual 2" Trailer Jack - Qty 1
- Shop: Buyers Products Ball Mount w/ 2" Ball - 3/4" Rise, 2" Drop - 8-1/2" Long - 5K
- Search Results: truck topper
- Q&A: Products That Allow For Truck Tailgate To Fold Down and Not Hit Jack On Trailer A-Frame When Towing
- Q&A: How Far Out Does the Pin on the Ultimate Trailer Jack # 322-RDJ-2K Stick Out
- Q&A: Lowest-Profile A-Frame Trailer Jack For Tailgate Clearance
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Q&A: Can I Install the Square A-Frame Jack w/ Footplate e74VV in a Round A-Frame Hole?
- Q&A: How To Stop A-Frame Jack From Scrapping Ground While Going Over Bumps
- Article: Holiday 2025 | Best Gifts for Towers
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Jacks



