Where is the Brake Controller Installation Plug on a 2000 Ford F-250

Question

Question:

2000 F350 SRW 4x4 7.3 diesel with 6-speed manual. Cannot find factory gray plug for wiring harness. Current 7-pin trailer plug at receiver is hot controls all lights and signals. But no brake controller so am trying to install Curt Triflex and harness both purchased from etrailer. Advice?

asked by: Kirk M

0

Expert Reply:

The plug you're looking for on your 2000 Ford F-250 is likely located behind some of the wire looms or possibly even tucked away in a nook off to the side when you remove the dash panel, but it will be there somewhere. Once you find this plug you'll be able to use the Curt Custom Wiring Adapter for Trailer Brake Controllers - Dual Plug In # C51322 to install the Curt Tri-Flex # C74VV. I've linked a few installation videos of brake controllers that use a brake controller adapter plug so you can get an idea of where it might be on your truck behind the wire looms or off to the side.

expert reply by: Erik B

0

Answer 1

To install a brake controller like our best selling controller the P2 part #90885 in your 1995 Ford F-250 you will need a couple components. First a controller like #90885, the correct install harness part #3035-P and then a 4-way to 7-way adapter…

view full answer...

Answer 2

The light on the Hopkins Brake-Force Brake Controller part 47225 will never be completely green. It will turn to varying degrees of orange as the brake pedal is pressed and power is applied. The light orange light (see photo) is the minimal setting…

view full answer...

Answer 3

The red wire is not supposed to be in the block on the harness when it is packaged. Hopkins leaves this last wire out so that the same part can be used for multiple model years. The end user needs to determine which slot it belongs in before the…

view full answer...

Answer 4

The Curt TriFlex Trailer Brake Controller part #C24VV is an excellent option for a 2008 Chevrolet Silverado when used with the Universal Wiring Adapter for Curt Trailer Brake Controllers part #C51515. The wires under the dash are already ran and…

view full answer...

Answer 5

Yes the wiring harness for your 2002 Ford F-350 Super Duty is indeed the same Curt brake controllers. The Curt brake controllers for your truck will use the Curt Wiring Adapter #C51322.

view full answer...

Answer 6

It sounds as if you might have the wrong wiring adapter. The wiring adapter for the 2002 and 2003 Silverado will fit either vehicle, but the order in which the pins are wired is different. Therefore, if you have the incorrect one, it will still plug…

view full answer...

Answer 7

Hello Terry. The white wire is generally the ground, and this should be true for the lights and the trailer harness. You can connect the white wires together and run them all to the same ground, or you can ground each wire individually. It really…

view full answer...

Answer 8

The process for hooking up a brake controller on your 1995 Ford F-250 is going to depend on if you have the factory 7-way, factory 4-way, or no factory connectors at all. For example, if you have the factory 7-way you would only need the brake…

view full answer...

Answer 9

Installing a 7-Way and 4-Way combination trailer connector, like part #HM40975-11998, that you referenced, on your 1995 Ford F-350 is fairly easy, but for these trucks there are 2 different wiring situations if you do not have a factory 7-way trailer…

view full answer...

Answer 10

For a 1995 Ford F-250 that never had trailer wiring you will first need to install #118316. Then you can install the 4- and 7-way installation kit #ETBC7. The other option is to use a circuit tester like #PTW2993 if needed to determine the functions…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Where is the Brake Controller Installation Plug on a 2000 Ford F-250

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching