Will The Malone AirFlow2 Roof Rack Be Able To Hold A Roof Top Tent?

Question

Question:

Will these cross bars hold an RTT? I’m looking specifically at the Smittybilt Overlander tent. Thank you.

asked by: Koren S

1

Helpful Expert Reply:

Yes, the Malone AirFlow2 Roof Rack - Aero Crossbars 50" # MPG215 will indeed be able to accommodate a roof top tent such as the Smittybilt Overlander. I do, however, recommend going with the slightly longer 58" Malone AirFlow2 Roof Rack # MPG216 as this would be a better option for large accessories such as a roof top tent. The weight capacity for the Malone AirFlow2 is 165lbs which is more than the weight of the Smittybilt Overlander according to the information I found.

Both of these crossbars are confirmed to fit the 2021 Subaru Crosstrek (excluding hybrid). I checked your owner's manual and your roof appears to have a weight capacity of 150lbs which is still over the weight of the Smittybilt Overlander, which is 139lbs according to my research. You will want to confirm the weight of your exact model tent that you are buying just to verify that you are not exceeding the weight limit of your roof or roof rack. I attached a demonstration video for you to check out regarding the Malone AirFlow2 Roof Rack.

expert reply by: Andrew N

1

Answer 1

I checked the owner's manual for your 2011 RAV4 and Toyota just states that you should not put more than 103lbs on top of the luggage rack so I cannot say for sure if adding aftermarket crossbars will increase your weight capacity or not. I…

view full answer...

Answer 2

If you purchased the Malone AirFlow 2 #MPG215 for your 2015 Toyota RAV4, the 165 pound weight limit is the maximum weight limit of the rack as long as your roof weight limit of your vehicle allows for such weight. Since your roof can only accommodate…

view full answer...

Answer 3

Hello Brandon, thanks for reaching out. The Malone AirFlow2 Roof Rack #MPG215 will fit the factory raised rails on your 2016 Subaru Crosstrek, and it has a 165 lb dynamic weight capacity which is enough to carry the tent. The static capacity of the…

view full answer...

Answer 4

Hi Adilson; if you just want a simple roof rack you will only use with the tent then the Malone AirFlow2 Roof Rack #MPG215 you looked at will do the trick. If you plan to keep this on all the time I would get the Thule WingBar Evo Roof Rack #TH52ZA…

view full answer...

Answer 5

The Malone Universal Crossbar System #MPG201 is a more economical choice but it still does a good job. The design and quality of Thule's system is why they have such a large difference in price. Whether you go with the Thule Crossroads system…

view full answer...

Answer 6

The Malone AirFlow2 Roof Rack part #MPG217 has a 165 lb weight capacity. In regards to rooftop tent carrier compatibility, you'll need to refer to the rooftop tent manufacturer. Take the Yakima SkyRise HD Tent for Roof Rack Crossbars part #Y07436…

view full answer...

Answer 7

I talked to Roofnest's customer service team regarding this situation. They were very helpful and said that you can certainly install the Sparrow XL onto your 2014 Subaru Forester as long as the roof rack and vehicle's roof has a weight…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 12

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Will The Malone AirFlow2 Roof Rack Be Able To Hold A Roof Top Tent?

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching