Recommended Grease to Use for Zerk Fittings of Curt TruTrac

Question

Question:

I was looking to get item numbers for the recommended grease to use in this distribution hitch.

asked by: Brian

0

Expert Reply:

The Curt TruTrac weight distribution system part # C17501 that you referenced does have grease fittings for lubrication and the correct grease to use is white lithium. We have white lithium grease in a cartridge with part # L11354.

expert reply by: Jameson C

0

Answer 1

Curt recommends the use of 250 ft. lbs of torque when tightening the nuts on their hitch balls like #C40034. The general rule is for a 3/4" shank tighten to 150 ft. lbs, for a 1" shank tighten to 250 ft. lbs, and for a 1 1/4" shank 450…

view full answer...

Answer 2

I looked at pictures of the Prime Time Avenger 27DBS and it does not appear that the frame is more narrow or even wider than any other A-frame. So it should be at the standard 50 degree angle as far as I can tell. That would mean that when installed…

view full answer...

Answer 3

A quality wheel bearing grease like #L11465 or the bearing grease you're already using would work just fine. You'll want to grease the trunnions by using the grease zerk and also brush some grease on the ball bearings above the trunnion as…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 7

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 8

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 9

Hey Steve, thanks for reaching out. We do have a good option for that. I recommend the following: - Curt TruTrack 2P Weight Distribution System w/ Sway Control - 7-Hole Shank - 8K GTW, 800 lb TW #C95MJ It’s designed for lighter trailers with 500–800…

view full answer...

Answer 10

Hey Ed! I reached out to NOCO and they said the Commercial Grade Battery Box for Group 4D Batteries #329-HM408 will be able to fit inside. There is enough flex, it will just be incredibly tight. This also means you won't have to try to fit the…

view full answer...

Recommended Grease to Use for Zerk Fittings of Curt TruTrac

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching