Recommended Replacement Landing Gear for a 2003 Keystone Challenger

Updated 05/12/2021 | Published 05/10/2021

Products Featured in This Question

Ultra-Fab Deluxe Electric Landing Gear Set - Weld On - 38" Lift - 12,000 lbs

(270)

$1151.93

Question:

I have a 2003 keystone challenger, 31 ft, 5th wheel and I need to replace the landing legs. What is the part number for both the legs?

asked by: Jill C

Expert Reply:

I was unable to find a standard landing gear that was used on the 2003 Keystone Challenger model campers, so I will not have a direct replacement. That being said, this does not mean we don't have an option available.

The Bulldog Tandem Landing Gear Set # BD500162 will have a bracket height difference of 17 1/2 inches. This will be measured from the bottom of the upper bracket to the top of the lower bracket. This can also adjust from 36 inches wide to 70 inches wide and is rated to 8,000 pounds. If these match your current landing gear, it will be a direct replacement.

Another potential option will be the Ultra-Fab Deluxe Electric Landing Gear Set # UF17-943010. This will not have any restrictions for the width as they are not connected to each other. It will measure a little differently at 14 1/2 inches from the top of the top bracket to the bottom of the middle bracket, or 20 1/4 inches from to the top of the top bracket to the bottom of the bottom bracket. This is also rated higher at 12,000 pounds.

It should be noted that both of these also come with their own brackets that can be welded on if the measurements do not match.

expert reply by: Lazer S