Do Hitches of 2021 Chrysler Pacifica Hybrid Install Differently

Question

Question:

I found your post recommending hitch e98903 for a 2021 Pacifica hybrid, but I understand the mounting process is different for a hybrid and standard, do you have mounting instructions specific to a 2021 Pacifica hybrid?

asked by: Joe W

1

Helpful Expert Reply:

There is a small difference in installing the etrailer.com Trailer Hitch Receiver part # e98903 on a Hybrid compared to a non-hybrid 2021 Chrysler Pacifica. There is an emissions canister on the driver side frame rail that needs to be relocated temporarily to install the hitch.

If you check out the attached install instructions link for this hitch on this page on step 5 you'll see this outlined.

expert reply by: Jameson C

1

Answer 1

Hello Leah, thanks for reaching out. Yep, it sure will! The etrailer Trailer Hitch Receiver #e98903 actually fits all models of the 2023 Pacifica. That includes the hybrid and non-hybrid models. What will you be using the hitch for? Are you towing a…

view full answer...

Answer 2

Great question Chuck! There is a minute difference in installing the etrailer.com Trailer Hitch Receiver part #e98903 on a Hybrid compared to a non-hybrid 2020 Chrysler Pacifica. There is an emissions canister on the driver side frame rail that needs…

view full answer...

Answer 3

We have both 1-1/4-inch Class II and 2-inch Class III hitches confirmed to fit the 2018 Chrysler Pacifica Hybrid that are shown on the linked page. Both Class II hitch #C12180 and Class III hitch #C13383 will require temporary removal and…

view full answer...

Answer 4

The etrailer.com hitch part #e98903 is a confirmed fit for your 2020 Chrysler Pacifica Hybrid and does have a couple extra steps for the hybrid models. There's an emissions canister that needs to be relocated temporarily when installing the hitch…

view full answer...

Answer 5

For installing the etrailer Trailer Hitch Receiver #e98903 the holes that may need enlarged are where you insert square hole spacers with the carriage bolts. It sounds like you did not have this issue on your particular vehicle. We do make mention of…

view full answer...

Answer 6

When the etrailer hitch part #e98903 was installed here we found that it measured 5 inches from the center of the hitch pin hole out to the rear bumper edge. Since that's not enough clearance for the Inno #INH540 and none of our other hitches…

view full answer...

Answer 7

Yes, the #e98903 that is displayed on etrailer.com will fit your 2021 Chrysler Pacifica; this is confirmed to fit both the hybrid and non-hybrid models.

view full answer...

Answer 8

The installation of the etrailer.com Trailer Hitch Receiver #e98903 will be the same as the Curt Trailer Hitch Receiver #C13383 for your 2019 Chrysler Pacifica Hybrid and I have attached the installation instructions of the Curt hitch for you so you…

view full answer...

Answer 9

Though I can provide the distance from the center of the pin hole to the closest edge of the bumper on the hitches we have installed, I cannot on the one we have not. This is the Curt Class II #C12180, unfortunately. That being said, the measurements…

view full answer...

Answer 10

When we installed the etrailer hitch part #e98903 on a 2021 Chrysler Pacifica like yours we found that it measured 5 inches from the center of the hitch pin hole out to the furthest point on the rear bumper. This will easily allow a Kuat NV bike rack…

view full answer...

Answer 11

Yes, the Curt Trailer Hitch Receiver #C13383 will fit your 2024 Chrysler Pacifica Touring Hybrid. This Class III hitch has a 2" receiver and a bolt-on installation. It also comes with a limited lifetime warranty. If you would prefer matte black…

view full answer...

Answer 12

That's a ground strap that you have circled in your picture. You can basically run that to any metal bolt that touches the metal frame and you'd be fine, but if you were to use it on the same bolt it would have to go over the hitch flange and…

view full answer...

Do Hitches of 2021 Chrysler Pacifica Hybrid Install Differently

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching