Where Are Fascia Removal Tabs Located on 2012 BMW 128i
Updated 04/07/2021 | Published 04/05/2021
Question:
where are the tabs that hold on the fascia?
asked by: Glenn B
Expert Reply:
I've linked the instructions for the Curt # C11184, but it shows the tab for the fascia; the tab should be located at the spot where the fascia meets the bumper. You will want to push in on the fascia to get it to disengage from the bumper. If you check out the linked instructions it shows 2 pictures- one of the bumper fascia tab and one where the fascia has been removed and the side plate is installed. The small holes there show where the tabs are going to catch on the bumper plate, so you'll just want to push on the fascia where those two pieces meet and it will pop the tabs out.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- For Towing
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: How to Install the Curt Trailer Hitch Receiver on a 2013 BMW 128i
- Q&A: Replacement Converter For Parallax 7355 Power Center Converter
- Q&A: How to Convert Parallax 7300 Model 7355 to Work with Lithium Batteries
- Q&A: What Kind of Batteries Does the Progressive Dynamics PD4655V Work with?
- Q&A: Instructions for Trimming Under Body Panel on a BMW 1 Series 135i
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Q&A: Is There Smaller 12 inch Trailer Tire that is Radial
- Q&A: Which is Better for Highway Use 4.80-12 or 5.30-12 Trailer TIres
- Article: How to Measure for Trailer Hitch Drop
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: How Does a Trailer Hitch Coupler Work?