Replacement Cover For Ram 3500lb Electric Trailer Jack

Question

Question:

I have a RAM 3500 electric trailer jack. I just broke my plastic cover by the switches. Do you know where I can get a pelacement?

asked by: Dave H

0

Expert Reply:

I am sorry to hear that the cover on your Ram 3500lb electric jack broke.

There are two different covers based on which jack you have. If you jack is the Electric Jack w/ Footplate - Drop Leg - A-Frame - 25-1/8" Lift - 3,500 lbs - White # EJ-3520-WBX you will need the Replacement Cover # EJ-3520-CVRW, or if you have the # EJ-3527-BBX you were looking at you will need the Replacement Cover # EJ-3520-BCV.

expert reply by: Samuel C

0

Answer 1

Based on images I can find for your 2012 Casita Spirt Deluxe it appears it came with a standard top wind jack like the #TJA-2002-B. Unfortunately, there is not a database like you have with cars to lookup parts since RV manufacturers do not keep…

view full answer...

Answer 2

Hey Leo, it sounds like the switch of your electric jack part #EJ-3527-BBX is bad or has become unplugged potentially. I would recommend checking the condition of the wires that run to the switch and fix as needed. If that looks good then it's…

view full answer...

Answer 3

I believe you're looking for the Replacement Manual Override Cap for etrailer A-Frame Electric Jack #EJ-3520-BCP. This will replace the manual override cap on your RAM 3.5K trailer jack, and is black in color.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 7

Hey Ken! The correct wiring harness depends on whether or not you have the brake controller port/plug. Some models did not include the plug so you will have to check your 2025 Ranger and see. There should be four wires coming out of a large wire…

view full answer...

Replacement Cover For Ram 3500lb Electric Trailer Jack

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching