Trailer Wiring for 2007 Jeep Commander

Updated 12/07/2020 | Published 12/04/2020

Products Featured in This Question

Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"

(418)

$168.37

Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(29)

$61.59

Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires

(3398)

$121.18

Question:

How do i tell if it was wired for a hitch or not?

asked by: JOHN H

Helpful Expert Reply:

If your 2007 Jeep Commander was equipped with a factory tow package there is going to be a wiring connector on the inside of your driver side rear bumper that our part # 118381 plugs into. If you have that connector then this is the part you need for a 4-way. Use part # HM42190 for a 7-way.

If you already have a hitch and no wiring it is likely someone installed the hitch and not the wiring and it's not factory installed. If it doesn't have a hitch someone could have taken off the factory hitch and wiring. If it's not factory, the correct hitch for your Commander is part # 75338. If you have a hitch and want a non factory 4-pole wiring harness you need part # C55414 and if you need a 7-way you can purchase the 4-pole harness and part # ETBC7.

expert reply by: Clayton O