Are There 63" Long Arm Solera 18v Smart Arm Conversions Available

Question

Question:

Is there a Solera 18V Power RV Awning Conversion Kit - with 63 Arms

asked by: Chad

0

Expert Reply:

I may have a solution for you to convert a manual awning to a powered awning, but I checked with Lippert on this and there is not a 63" version of the Solera 18v Power RV Awning Conversion Kit like the # LC434730.

However, if you're looking to convert from a manual awning to a powered awning you could use the Solera Smart Arm 12V Power RV Awning Conversion Kit - Programmable - 63" Arms - Black # LC759516 or Solera Smart Arm 12V Power RV Awning Conversion Kit - Programmable - 63" Arms - White # LC759404. This smart arm conversion kit would connect to the coach's battery power instead of operating off a 12v battery, but would be a good solution to replace manual drive head awnings.

expert reply by: Erik B

0

Answer 1

The Solera 18V Power RV Awning Conversion Kit #LC434730 is an upgrade kit that is confirmed as a replacement for your Carefree Fiesta 18 ft manual awning. These arms will install in the same locations as your current awning arms and they just need…

view full answer...

Answer 2

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 3

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

Hey Brady, Brophy in the past has told us that the tie downs part #HSWB don't have a weight capacity but you would want to make sure you use them only with campers that were designed to fit the bed length of the truck. The turnbuckles part #TDHP…

view full answer...

Answer 6

There is no weight capacity for the Brophy Clamp On Camper Tie-Downs #HSSF. The tie-down hardware kit #TDHP, that is used to secure the camper to the #HSSF tie-downs has a weight capacity of 3,000-lbs. My contact at Brophy said the tie-downs will…

view full answer...

Answer 7

You can use the Brophy Clamp On Camper Tie-Downs #HSAB for your 2018 Ford F-350 Super Duty but we actually recommend going with the Camper Tie-Downs #HSSF instead as they have a slightly different design that better fits your Super Duty. Attached are…

view full answer...

Answer 8

Hello Shonda, thanks for writing in. There is not a specific weight rating for the Brophy Slide In Camper Tie-Downs #HSSF. They will work with any camper that is properly sized for your truck. So as long as the camper fits in the truck bed and weighs…

view full answer...

Are There 63" Long Arm Solera 18v Smart Arm Conversions Available

Product Page this Question was Asked From

Continue Researching