Suspension Enhancement for Lowered 2007 Toyota Tacoma

Question

Question:

Will this work the same on a lowered truck? or will it push the rear end back up?

asked by: Chance

0

Expert Reply:

Yes; the best option - so long as your 2007 Tacoma has factory leaf springs and a lower overload spring - is the TorkLift StableLoad Suspension Upgrade # TLA7311S.

These are compatible with lowered trucks, and work by bolting onto the ends of each overload spring on your Tacoma, and essentially "activate" it early by filling in the gap between your leaf springs and the overload spring. This will give you a much more stable, controlled ride, particularly when you have a load in the truck.

I have added a link below to a video review I recommend checking out as well of the TorkLift StableLoad Suspension Upgrade # TLA7311S.

expert reply by: Kyle S

0

Answer 1

I would be happy to and congrats on your new truck! The best are going to be the TorkLift ApexAnchors Truck Camper Tie-Downs item #TL37QV. These are brand new and mount inside the bed of your Tacoma. They do not affect your ground clearance and…

view full answer...

Answer 2

Hey Bill, the Torklift ApexAnchors Tie Downs part #TL37QV that fit your 2019 Toyota Tacoma install by attaching to the frame of your truck through the bed. So you'll need to drill a hole in your truck bed and attach the tie downs to the frame…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 7

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 8

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 12

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Suspension Enhancement for Lowered 2007 Toyota Tacoma

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching