Replacement Tool for Reese 5th Wheel Rail Adapter for Ram OEM

Question

Question:

I need to purchase the wrench tool that tightens nut so in latch fits tighter. Where can I buy this. Thank you

asked by: Jeff B

0

Expert Reply:

I spoke with Reese and they stated the Wrench for Reese Fifth Wheel Hitch Installation Rails or OEM Adapter part # 58276 works great with the Reese 5th Wheel Rail Adapter for Ram OEM part # RP30154. It looks a tad different that the tool that originally came with the adapter but nonetheless will still work great.

expert reply by: Conner L

0

Answer 1

The Wrench for Elite Series Fifth Wheel Hitch Installation Rails #58276 that you referenced is designed for tightening the 1 inch jam nut to the anchor bushing and legs of an Elite or Signature series hitch. Access is pretty limited in there and that…

view full answer...

Answer 2

First, make sure that when you are inserting the Reese adapter #RP30154 into the pucks on your 2014 Ram that the handles are not in the locked position. Installation of this adapter will require some fine tuning due to slight variations from truck to…

view full answer...

Answer 3

For your Palomino HS-8801 the Camco UltraGuard part #CAM45770 would be a great option that is the correct size to fit, is easy to install, and provides great protection in all climates.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 10

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Replacement Tool for Reese 5th Wheel Rail Adapter for Ram OEM

Continue Researching