Do Frame Holes Need to be Enlarged to Install Draw-Tite Trailer Hitch on 2019 Subaru Forester

Updated 08/23/2020 | Published 08/22/2020

Products Featured in This Question

Draw-Tite Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"

(54)

$169.44

T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(2968)

$43.75

Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"

(461)

$186.90

Question:

Hello! I watched your installation video and it was great. I believe it was for a 2020 forester, and no enlargement of the frame rail holes was necessary. Is that also true for a 2019 forester? I would rather get the Curt class 2 hitch because it costs a good amount less, but it requires enlarging the holes. Please confirm the Draw Tite hitch does not require enlarging the frame rail holes on a 2019 forester. Thanks!!

asked by: Ross

Helpful Expert Reply:

I can confirm for you that you do not need to enlarge any holes in the frame of your 2019 Subaru Forester in order to install either of the Draw-Tite trailer hitches that fit your vehicle:

- Class II with 1-1/4" Receiver: Draw-Tite Trailer Hitch Receiver # 36671

- Class III with 2" Receiver: Draw-Tite Trailer Hitch Receiver # 76271

The reason is, the Draw-Tite hitches use the larger rear frame access hole to fishwire the spacers and bolts through, so the hardware will fit without needing to be enlarged.

Additionally, I wanted to mention that if you were going to be using this hitch for towing and needed a wiring harness, the correct part is the T-One Vehicle Wiring Harness # 118467.

expert reply by: Kyle S