What Axle Does Replacement Snap-In Grommet # 046-124-00 Fit

Question

Question:

Info necessary to purchase any grommet: hole size, axle tube thickness.

asked by: Michael

0

Expert Reply:

The replacement snap-in grommet part # 046-124-00 that you referenced fits 6,000 lb Dexter axles. If you can verify that you have a 6k Dexter axle this would be the correct fit for it.

expert reply by: Jameson C

0

Answer 1

Dexter has confirmed that the #046-124-00 snap in grommet will work with their 7K axles.

view full answer...

Answer 2

Yes, you can use 10 Gauge Wire #10-1-1 to route through your axles to power your Electric Brakes #K23-478-00 Do be sure the Grommet #046-124-00 is in place on your axle tube to prevent the wire from fraying entering the axle tube.

view full answer...

Answer 3

The diameter of the Replacement Brake Wire Grommet #046-016-00 is 3/8" with a length of 7/16". I have attached a video that goes over these measurements at the 25 second mark of the video.

view full answer...

Answer 4

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 5

You'll need a 20 amp circuit breaker for the brake controller power and a 40 amp circuit breaker for the battery charge line circuit from the trailer connector for a total of two. We actually offer a kit with these circuit breakers as well as the…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 10

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

What Axle Does Replacement Snap-In Grommet # 046-124-00 Fit

Product Page this Question was Asked From

Continue Researching