Hardware Used to Mount Optronics 7-Way Trailer Harness Plug Protector
Updated 07/14/2020 | Published 07/10/2020
Products Featured in This Question
Question:
I received the part today but there were no screws with it, which as I now see in the description, that is ok. However, what screws should I use and how should I mount it on my trailer, which is an Aliner camper? Thank You.
asked by: TED F
0
Expert Reply:
You can use whatever hardware works best for you and the location on your trailer that you want to mount the Optronics 7-Way Trailer Harness Plug Protector # ACP7B. When we installed the protector in the linked video, we used Self-Tapping Screws 1/4 Inch # FA1131822.
expert reply by:
Victoria B
0
Product Page this Question was Asked From
Optronics 7-Way Trailer Harness Plug Protector
- Accessories and Parts
- Trailer Wiring
- Wire Protection
- Connector Covers
- 7 Blade
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Q&A: Why Are 5th Wheel Wiring Harnesses So Long?
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Looking for Trailer Wheel/Tire with 5 on 4-3/4 inch Bolt Pattern
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: What is Pilot Diameter of Kenda Karrier KR53 ST205/75R15 Radial Trailer Tire with Wheel
- Q&A: Looking for a Printable Wheel Bolt Pattern Template
- Q&A: Recommended Hitch for a 2006 Chevy Silverado 2500HD w/ a 6-1/2' Bed and the Factory Bumper
- Q&A: Wet Bolt Kit for 2025 Keystone Coleman Light 17RX
- Article: Best Tire Chains
- Article: Snow Tire Chains Review
- Article: Snow Tire Chain Overview: How to Buy the Right Tire Chains