How to Determine if CIPA and K-Source Slip-On Mirrors Will Fit 2019 Ram 1500 Classic SLT

Question

Question:

I like these mirrors and the CIPA mirrors, however they both dont seem to be compatible with the SLT model mirrors. I have a 2019 Ram 1500 Classic SLT Canada and my mirrors look like the same as the other models. Is it possible that I might have the regular sized mirrors? How would I check to see whether I have the SLT mirrors or not?

asked by: Aaron L

0

Expert Reply:

From what I could find it looks like there are a few different version of mirrors that come on a 2019 Ram 1500 Classic SLT. Basically as long as your mirrors look like the picture I attached you should be good to go. I'm also attaching a link to an install video we did of the CIPA # CM11400 mirrors on a 2019 Ram 1500 Classic (that looks to have the same type of mirrors that you have) that you can check out.

I'd personally go with the CIPA # CM11400 over the K-Source # KS80710 simply because the K-Source has a cutout at the bottom to accommodate for lights on the housing so if you don't have them it will be noticeable.

expert reply by: Jon G

0

click to enlarge

Michael

8/4/2025

Hello, I also have a 2019 Ram 1500 Classic. I am however hauling a truck camper and have difficulty seeing what is behind the camper with my stock mirrors. Will the CIPA 11400's help actually seeing what is behind the truck camper? Thank you very much. Mike P.

Jon G.

8/4/2025

@Michael Yes, this will be a great way to gain some extra sight along the sides of your truck camper! If you're wanting to see directly behind your camper, then we'll need to get you setup with backup camera. Are you wanting to go that route?

Michael

8/5/2025

Hello Jon G. I would certainly entertain the possibility. Do you recommend a certain budget product? I am not really very tech savvy and prefer simple electronics that get the job done. Thanks for the help. Mike P.

Jon G.

8/5/2025

@Michael What I recommend going with is the Furrion Vision S+ Wireless RV Backup System # FR57AD because it's wireless and really reliable. We do have more of a budget item with the Hopkins VueSMART # HM34FR that uses your phone as the monitor, but this setup isn't as reliable.

Answer 1

Try unplugging the brake controller for 10 seconds or so and then replugging it in. Sometimes brake controllers like the part #C24VV just need to be reset and this is the corret way to do that.

view full answer...

Answer 2

Hey Ken. The K-Source Custom Flip Out Towing Mirrors item #KS60199-00C, you were looking at are factory replacements for your 2014 Dodge Ram's mirrors. I checked with K-Source and they come with everything you need to install them. What HD…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 7

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 8

You're right, the mounting bracket is unique (in a good way) for the Curt TriFlex NEXT Trailer Brake Controller #C24VV. The bracket is smaller and all you do is put the included adhesive tape on the bracket and stick it wherever you like under…

view full answer...

Answer 9

Hi there Chris, great question. Yes the Redarc #RED87CR is truly a plug and play brake controller for your 2026 Ram 1500. It connects directly to the factory tow controller connector under the dash, so there’s no dealer programming required like you…

view full answer...

Answer 10

Hello Kevin, Thanks for writing in. The main difference between the Power Watchdog Surge Protectors #HU67FR and #HU42VR comes down to the monitoring capability, housing design, and surge protection rating. The #HU67FR is the newer Generation 2 model.…

view full answer...

Answer 11

Hey Bob. There's two possible locations for the brake controller port on your 2026 Ford F-150. The most likely one is on your dash behind the coin holder above the 4WD knob. It'll be connected to the back of the coin tray which is only…

view full answer...

Answer 12

Hey Erik, It's common for the light on your Furrion stove's knob to stay on if it senses that the oven is on. Since you're clearly not running the oven but it's still on and staying red instead of changing to blue that would indicate…

view full answer...

How to Determine if CIPA and K-Source Slip-On Mirrors Will Fit 2019 Ram 1500 Classic SLT

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching