Can you Attach a Ball Mount to the End of a Cargo Carrier to Tow a Boat Trailer

Question

Question:

Can you attach a ball hitch to carrier and pull a 2,500lb boat?

asked by: Al

0

Expert Reply:

I do have an option that will allow you to carry a cargo carrier and tow your 2,500 lb boat, however, a ball mount cannot attach to the end of a cargo carrier to tow a trailer. Instead, check out the Curt Multipurpose Ball Mount, # D210. This ball mount will allow you to tow your trailer with the lower ball mount and carry your cargo carrier using the receiver.

The towing capacity of this ball mount is 7,500 lbs and the tongue weight capacity is 750 lbs. The receiver weight capacity is 350 lbs. The recommended 2 inch hitch ball for this ball mount is part # 19247.

I would recommend looking into a cargo carrier with a bend in the shank like the Pro Series Cargo Carrier, # 63153. This will give the cargo carrier plenty of lift over the tongue of your trailer. I have attached a video review of this cargo carrier for you to check out.

expert reply by: John H

0

Answer 1

When it comes to having a 7 way plug and a 4 flat plug on your 2013 Honda Pilot without splicing wires we have a bunch of adapters they can plug into the 7 way to make it a 4 flat We have The T-One Vehicle Wiring Harness for Factory Tow Package -…

view full answer...

Answer 2

When determining the needed rise or drop to tow the trailer level with your 2012 Honda Pilot, you will just want to take a couple measurements. First, with the trailer parked on level ground, you will take a measurement from the ground to the bottom…

view full answer...

Answer 3

Your 2012 Honda Pilot has a trailer hitch installed on it from the factory so for wiring you have two options. If the trailer you plan tow has a round connector you would need a 7-way like what the #118265 would give you. If instead it is a flat…

view full answer...

Answer 4

78" bars on a 2012 Honda Pilot is possible. You will need a specific kit to do so and check your local laws and ordinances for any requirements for flagging your load. If the 78 inch bar, part #Y00411 isn't legal in your area, you can use…

view full answer...

Answer 5

In order to determine what drop, if any, is needed on a ball mount to tow your Meadow Creek BBQ trailer level with your Honda Pilot, you will just need to take a quick measurement on both the Pilot and the trailer. Starting on your Honda Pilot with…

view full answer...

Answer 6

The 2012 Honda Pilot should have been equipped with a factory trailer hitch, which is why you're unable to find an aftermarket model. Check the rear bumper fascia for a removable panel or door that is hiding the hitch receiver. Once removed, the…

view full answer...

Answer 7

You'd need a 4-way trailer wiring harness for your 2012 Honda Pilot since you said it's a smaller trailer and for the you'd need the part #118558 which installs by plugging into factory connections already present for trailer wiring.…

view full answer...

Answer 8

There are trunk mount bike racks that will fit the 2012 Honda Pilot, see link, but the Thule racks will not fit. There are ways to tow a trailer and use a hitch mount rack together, though. You can use dual-purpose ball mount #D210. The overall…

view full answer...

Answer 9

Are you looking for a wiring harness to power a trailer's lights or the ball mount that slides into the factory hitch receiver on your 2012 Honda Pilot and then holds the hitch ball that the trailer connects to? Either way we have what you need.…

view full answer...

Answer 10

There are a lot of options for brake controllers on the market that work with your 2012 Honda Pilot. The Curt Venturer Trailer Brake Controller #C74VV is a basic time-delayed controller that mounts in the cab of your vehicle. With a time-delayed…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Can you Attach a Ball Mount to the End of a Cargo Carrier to Tow a Boat Trailer

Products Featured in This Question

Featured Help Information

Miscellaneous Media

Continue Researching