Will Dutton Lainson Winch DL15440 Fit Same Bolt Pattern as Shelby 5466

Question

Question:

Does the Dutton Lanson 15440 have the same bolt pattern as the Shelby 5466?

asked by: Thomas M

0

Expert Reply:

Yes the bolt pattern of the Dutton-Lainson Hand Winch # DL15440 is close enough to the Shelby you mentioned that it would easily fit in place of it.

expert reply by: Jameson C

0

Answer 1

For the similar winch with strap, I recommend the Dutton-Lainson Hand Winch - TUFFPLATE Finish - 2 Speed - Direct Drive - 2,500 lbs #DL14825 and then adding the Hand Winch Strap with Safety Hook, 2" Wide x 25' Long - 4,000 lbs #DL24249.…

view full answer...

Answer 2

We have some very similar winches to the Shelby 5466 that you have but we do not carry Shelby winches any longer. The Shelby is a 2 speed winch with a 2,300 lb capacity so for a very similar winch we have the Dutton Lainson 2 speed winch part…

view full answer...

Answer 3

The Dutton-Lainson DL2500AB Pulling Winch, part #DL14830, has a rated horizontal pulling capacity of 2500 pounds. It is not rated adequately to pull your 3020-lb boat onto its bunked trailer. We offer the 3200-lb-rated Dutton-Lainson model DL3200A,…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 11

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 12

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Will Dutton Lainson Winch DL15440 Fit Same Bolt Pattern as Shelby 5466

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching