Location of Brake Controller Unit Port on 2016 Toyota Sequoia Platinum

Question

Question:

Have been standing on my head trying to locate this and have every panel off the vehicle. Could you please send the video referenced in the 2015 Sequoia SR5 QandA attachment response to me as well Thanks.

asked by: Cath

0

Expert Reply:

The video being referenced on the question page you were looking at is for a 2008 Toyota Sequoia and I've linked it to this answer page for you to check out.

The video shows how to install the older Prodigy 90185 brake controller (which was replaced/upgraded by the P2 # 90885) and the wiring adapter # 3040-P.

expert reply by: Jon G

0

Answer 1

For starters, you are going to want to remove the three button panel to the right of the steering wheel and look for a white rectangular connector with four pins. If present this is present then we do have a plug-in option available for you in the…

view full answer...

Answer 2

Actually, the P3 now has the upgraded axis accelerometer like the P2. The Tekonsha P3 Trailer Brake Controller #90195, will work with both electric over hydraulic brakes on the trailer as well as electric brakes. It has a menu option on the display…

view full answer...

Answer 3

Since your 2008 Toyota Sequoia came with a factory tow package, you can plug in the wiring harness, #3040-P into the port on the vehicle. It is located under the dash to the left of and above the the emergency brake. You will remove the panel that is…

view full answer...

Answer 4

You have come to the right place, we have a video showing the installation of a brake controller on a 2007 Toyota Tundra that will be identical to your installation. I have also included a link to the instructions for the Tekonsha Prodigy P2 Brake…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

The problems you are having with the factory brake controller on your 2018 Toyota Tundra, as you mentioned, are not too uncommon. This is really the case with most factory brake controllers regardless of the truck make or model, as many customers…

view full answer...

Answer 7

I took a look at the online owner's manual for your 2013 Toyota 4Runner and found that it can safely tow a trailer that weighs up to 5,000 pounds, assuming that the trailer is equipped with brakes. With this in mind, your 4Runner certainly has…

view full answer...

Answer 8

From our experience the brake controller connector on a Toyota Sequoia is pretty tucked away. It's in a similar location as to the Tundra video you watched but harder to find. Take a look at the video I linked of the 2008 Sequoia, it's the…

view full answer...

Location of Brake Controller Unit Port on 2016 Toyota Sequoia Platinum

Featured Help Information

Miscellaneous Media

Continue Researching