Are There Center Caps Available for Dexstar Mini Mod Trailer Wheels

Question

Question:

Which center cap is compatible with rim part # AM20794

asked by: Jordan K

0

Expert Reply:

I have a solution for you, but I did some searching and it doesn't look like we have any available center caps that are going to be compatible with the Dexstar Steel Mini Mod Trailer Wheel # AM20794. If you're looking for a little bit better looking wheel that won't break the bank, have a look at the Aluminum Liger Trailer Wheel - 16" x 6" Rim - 8 on 6-1/2 - Black # LH39FR. These are also an 8 on 6-1/2 bolt pattern 16" diameter wheel that gives you a good balance of price and good looks. You can use the Lionshead Trailer Wheel Center Cap w/ Snap-In Plug - 4.88" to 4.9" Pilot - Stainless # LHCS109-SI60C as the center cap on these wheels, which will give you protection for your spindles and provide you with a great finished look.

I've also linked our entire selection of 16"- 8 on 6-1/2 bolt pattern wheels for you to have a look at.

expert reply by: Erik B

0

Answer 1

Backspacing and offset are terms used to look at the same thing in a different way. Backspacing is described as the distance from the center of the hub to the inside edge of the wheel at the bead seat whereas offset is the distance from the center of…

view full answer...

Answer 2

For what you are looking for the most ideal setup will be one that has more sidewall than the 17.5 inch wheel setup you referenced as the more sidewall you have the more the footprint can easily expand when aired down. So going with a 16 inch wheel…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 11

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Are There Center Caps Available for Dexstar Mini Mod Trailer Wheels

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching