Plug In Location for Brake Controller Wiring on a 2016 GMC Sierra 1500

Question

Question:

Wheres the plugin located under the dash - for the trailer brake assembly for 2016 GMC Sierra 1500

asked by: Kenneth L

0

Expert Reply:

The plug in location for a brake controller on your 2016 GMC Sierra 1500 is in the black electric junction box located to the left of the brake pedal. I've attached a photo showing where this is at for a plug in like the part # 3016-S which would be used to install the Redarc Tow-Pro Elite # RED44FR.

expert reply by: Jon G

0

click to enlarge

Answer 1

There is existing wiring under the dash on your 2016 GMC Sierra 1500. Your truck comes with a pre-wired factory tow package which means it is set up to easily install a brake controller. The plug-in wiring harness sits right under the dashboard above…

view full answer...

Answer 2

Since your 2016 GMC Sierra 1500 already has a 7-way trailer connector at the rear of the vehicle then all you will need to install a brake controller is the brake controller and wiring harness adapter. I am not sure what the "work model" of…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

The Redarc Tow-Pro Liberty #RED24FR is the way to go over the Elite #RED44FR as you get the nicer functions of the Elite at a lower price. The Elite has the ability to be the more preferred proportional style of controller as well as a time-delayed…

view full answer...

Answer 11

We can get you everything you need for towing with your 2017 Toyota Sienna XLE. By plastic shield, I believe you are referring to the appearance panel underneath the Sienna, and that will have to trimmed a bit in each of the hitches available for the…

view full answer...

Answer 12

Not another one! Just kidding Dirk! I was in the Marines I enjoy these conversion questions on the M1101 trailers. I'd be more than happy to list the parts you need, along with quantity, and confirm compatibility. 1 - Timbren Axle-Less Trailer…

view full answer...

Plug In Location for Brake Controller Wiring on a 2016 GMC Sierra 1500

Products Featured in This Question

Continue Researching