How to Add an Electric Trailer Jack to a Trailer
Updated 04/25/2020 | Published 04/23/2020
Products Featured in This Question
Question:
can this jack be wired to plug into the four prong hitch terminal?
asked by: Larry H
Expert Reply:
Pretty much all electric trailer jacks require a direct battery connection to function properly. The circuits on a 4-pin trailer connector do not provide a big enough wire gauge or a suitable amp rating to power an electric trailer jack. The fuse/circuit protection on those wires would fail or the wires would overheat before the jack would start moving.
Your best option for adding an electric trailer jack like the etrailer.com Electric Jack # EJ-3520-BBX to a trailer is to also add a 12 volt battery to the trailer. If you go this route, I'd also recommend upgrading the trailer connectors on your tow vehicle and trailer to 7-way connectors to keep the trailer battery charged. You would need the following parts to complete this setup
Vehicle Side
4-Pin to 7-Pin Upgrade Kit # ETBC7
Trailer Side
7-Way Upgrade Kit # HS381-9000
Product Page this Question was Asked From
Electric Jack w/ Footplate - A-Frame - 25-1/8" Lift - 3.5K - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jacks
- Steel
- 3001 - 4000 lbs
- Electric Jack
- 18 Inch Lift
- Bolt-On
- 1 Jack
- RAM
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Electric Jack w/ Footplate - A-Frame - 25-1/8" Lift - 3.5K - Black
- Video: Review of etrailer Trailer Camper Jack Parts - Replacement Manual Jack Handle - EJ-3520-HD
- Video: etrailer Replacement Manual Jack Handle Review
- Shop: Replacement Manual Jack Handle for etrailer or RAM Electric A-Frame Jack
- Shop: Stromberg Carlson Electric A-Frame Tongue Jack - 18" Lift - 2,500 lbs
- Shop: Ultra-Fab Protective Cover for Electric A-Frame Jacks - Vinyl - 10-1/2" x 13-3/4"
- Q&A: Could Foot of Electric Jack # EJ-3520-BBX All the Slide Out with Pin Removed
- Q&A: What Gauge Wire Should be Ran to Trailer Powered Jack Motor
- Q&A: Does the Electric Jack with Footplate Need a Ground to Function
- Q&A: Power Connection for etrailer Electric Tongue Jack EJ-3527-BBX
- Q&A: Installing the Wiring on Lippert Power Stabilizer Jack
- Q&A: Adding An On-Board Trailer Battery to Trailer for Electric Power Tongue Jack
- Q&A: How To Wire EJ-3520-BBX Jack Directly To A Trailer Battery
- Video: etrailer Electric Jack with Footplate Installation - 2011 Forest River Flagstaff Classic Super Lite
- Shop: Electric Jack w/ Footplate and 7-Way Plug - A-Frame - 25-1/8" Lift - 3.5K - Black
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires